Related papers: Low-Complexity Hybrid Beamforming for Multi-Cell m…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…
In this paper, we investigate hybrid analog/digital beamforming for multiple-input multiple-output (MIMO) systems with low-resolution analog-to-digital converters (ADCs) for millimeter wave (mmWave) communications. In the receiver, we…
The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…
Future cellular systems based on the use of millimeter waves will heavily rely on the use of antenna arrays both at the transmitter and at the receiver. For complexity reasons and energy consumption issues, fully digital precoding and…
Deploying massive number of antennas at the base station side can boost the cellular system performance dramatically. Meanwhile, it however involves significant additional radio-frequency (RF) front-end complexity, hardware cost and power…
Analog/digital hybrid beamforming architectures with large-scale antenna arrays have been widely considered in millimeter wave (mmWave) communication systems because they can address the tradeoff between performance and hardware efficiency…
This work studies a variant of hybrid beamforming, namely, hybrid beamforming with selection (HBwS), as an attractive solution to reduce the hardware cost of multi-user Massive Multiple-Input-Multiple-Output systems, while retaining good…
Hybrid analog and digital beamforming has emerged as a key enabling technology for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) communication systems since it can balance the trade-off between system performance…
In this paper, we propose a novel joint hybrid precoder and combiner design for maximizing the average achievable sum-rate of single-user orthogonal frequency division multiplexing millimeter wave massive MIMO systems. We formulate the…
The uplink where both the transmitter and receiver can use a large antenna array is considered. This is proposed as a method of antenna offloading and connecting small cell access points (SCAP) in a Two-Tier cellular network. Due to having…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
Full-duplex (FD) systems gained enormous attention because of the potential to double the spectral efficiency. In the context of 5G technology, FD systems operating at millimeter-wave (mmWave) frequencies become one of the most promising…
Over-the-air computation (AirComp) has been recognized as a promising technique in Internet-of-Things (IoT) networks for fast data aggregation from a large number of wireless devices. However, as the number of devices becomes large, the…
Full duplex (FD) is an auspicious wireless technology that holds the potential to double data rates through simultaneous transmission and reception. This paper proposes two innovative designs of hybrid beamforming (HYBF) for a multicell…
The main challenges in designing downlink coordinated multicast beamforming in massive multiple-input multiple output (MIMO) cellular networks are the complex computational solutions and significant fronthaul overhead for centralized…
This study investigates subarray-level movable antenna (MA) architecture for multi-user MIMO (MU-MIMO) systems. Unlike conventional systems with fixed-position antennas (FPAs), the proposed scheme harnesses the additional positional degrees…
In this paper, adaptive hybrid beamforming methods are proposed for millimeter-wave range massive multiple-input-multiple-output (MIMO) systems considering single carrier wideband transmission in uplink data mode. A statistical analog…
In this paper, we propose a beamforming design for dual-functional radar-communication (DFRC) systems at the millimeter wave (mmWave) band, where hybrid beamforming and sub-arrayed MIMO radar techniques are jointly exploited. We assume that…
To develop a low-complexity multicast beamforming method for millimeter wave communications, we first propose a channel gain estimation method in this article. We use the beam sweeping to find the best codeword and its two neighboring…
Data rate requirements for cellular communications are expected to increase 1000-fold by 2020, compared to 2010. This is mainly because of the rapid increase in the number of wireless devices and data hungry applications per-device. This…