Related papers: Detachment control in KSTAR with Tungsten divertor
Although deep learning models owe their remarkable success to deep and complex architectures, this very complexity typically comes at the expense of real-time performance. To address this issue, a variety of model compression techniques…
The metal-to-metal clearances of a steam turbine during full or part load operation are among the main drivers of efficiency. The requirement to add clearances is driven by a number of factors including the relative movements of the steam…
We propose a novel method to constrain the spatial extent of dust around galaxies through the measurement of dust temperature. Our method combines the dust emission of galaxies from far-infrared (FIR) image stacking analysis and the quasar…
We report on the experimental characterization of the RIT-2.5 radiofrequency ion thruster, complemented by particle-in-cell (PIC) simulations to establish correlations between plasma parameters and extracted beam properties. The thruster…
The power load to the divertor surfaces is a key concern for future devices such as ITER, due to the thermal limits on the material surface. One factor that characterizes the heat flux to the divertor is the fall off length in the…
Numerical simulations of interchange turbulence in the Scrape-Off Layer are performed in a regime relevant for a specific L-mode MAST (Mega Ampere Spherical Tokamak) discharge. Such a discharge was diagnosed with a reciprocating arm…
This study introduces the divergence-conforming discontinuous Galerkin finite element method (DGFEM) for numerically approximating optimal control problems with distributed constraints, specifically those governed by stationary generalized…
Using quantum gas microscopy we study the late-time effective hydrodynamics of an isolated cold-atom Fermi-Hubbard system subject to an external linear potential (a "tilt"). The tilt is along one of the principal directions of the…
Edge localised modes (ELMs) are a concern for future devices, such as ITER, due to the large transient heat loads they generate on the divertor surfaces which could limit the operational time of the device. This paper discusses the…
The scrape-off layer (SOL) power width (\lambda_q) is important for predicting the heat load on divertor targets for future magnetically confined devices. Currently, the underlying physics for \lambda_q scaling is not fully understood. This…
In this paper, we develop a numerical scheme to handle interfaces across computational domains in multi-block schemes for the approximation of systems of conservation laws. We are interested in transmitting shock discontinuities without…
A new analysis technique for the inference of degree of dissociation of weakly collisional hydrogen plasmas was developed and tested with an experiment. Neutrals in low temperature plasmas are critical to a wide range of plasma-based…
The disruption and runaway electron analysis model code was extended to include tungsten impurities in disruption simulations with the aim of studying the runaway electron (RE) generation. This study investigates RE current sensitivity on…
Tungsten (W) is the leading candidate material for plasma-facing components in fusion reactors, yet its upper operational temperature is limited by premature grain growth and recrystallization processes. Irradiation adds further…
High-precision low-temperature thermometry is a challenge for experimental quantum physics and quantum sensing. Here we consider a thermometer modelled by a dynamically-controlled multilevel quantum probe in contact with a bath. Dynamical…
We introduce a variation of the dissipative particle dynamics (DPD) thermostat that allows for controlling transport properties of molecular fluids. The standard DPD thermostat acts only on a relative velocity along the interatomic axis.…
An effective radiative divertor maximizes the utilization of atomic processes to spread out the energy deposition to the divertor chamber walls and to reduce the peak heat flux. Because the mixture of neutral atoms and ions in the divertor…
The XGC1 edge gyrokinetic code is used for a high fidelity prediction for the width of the heat-flux to divertor plates in attached plasma condition. The simulation results are validated against the empirical scaling $\lambda_q \propto…
Achieving self-consistent performance predictions for ITER requires integrated modeling of core transport and divertor power exhaust under realistic impurity conditions. We present results from the first systematic power-flow and…
Edge localised modes (ELMs) are a concern for future devices as they can limit the operational lifetime of the divertor. The mitigation of ELMs can be performed by the application of resonant magnetic perturbations (RMPs) which act to…