Related papers: High Performance Signal Design for Optical OFDM Sy…
Orthogonal frequency division multiplexing with index modulation (OFDM-IM) is a novel scheme where the information bits are conveyed through the subcarrier activation pattern (SAP) and the symbols on the active subcarriers. Unfortunately,…
Low peak-to-average power ratio (PAPR) orthogonal frequency division multiplexing (OFDM) waveform design is a crucial issue in integrated sensing and communications (ISAC). This paper introduces an OFDM-ISAC waveform design that utilizes…
In this paper, we propose two low-complexity peak to average power ratio(PAPR) reduction algorithms for orthogonal frequency division multiplexing(OFDM) signals. The main content is as follows: First, a non-convex optimization model is…
Orthogonal frequency-division multiplexing (OFDM) in visible light communications (VLC) inherits the disadvantage of high peak-to-average power ratio (PAPR) from OFDM in radio frequency (RF) communications. The upper peak power and lower…
Signal clipping is a classic technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. It has been widely applied in consumer electronic devices owing to its low complexity and…
In wireless communication systems, the nonlinear effect and inefficiency of power amplifier (PA) have posed practical challenges for system designs to achieve high spectral efficiency (SE) and energy efficiency (EE). In this paper, we…
The OFDM waveform exhibits high fluctuation in the signal envelope which causes distortion in the nonlinear power amplifier of the transmitter. Peak-to-Average Power Ratio (PAPR) and Cubic Metric (CM) are the common metrics to quantify the…
Orthogonal frequency-division multiplexing (OFDM) time-domain signals exhibit high peak-to-average (power) ratio (PAR), which requires linear radio-frequency chains to avoid an increase in error-vector magnitude (EVM) and out-of-band (OOB)…
The high peak-to-average-power ratio (PAPR) of orthogonal frequency-division multiplexing (OFDM) degrades the performance in optical wireless communication systems. This paper proposes a modified asymmetrically clipped optical OFDM…
Future 6G wireless networks will once again have to raise the capability in most of the technology domains by a factor of 10-100. Depending on the application, future requirements include peak data rates of 1Tb/s per user, 0.1ms latency,…
This paper is concerned with the performance improvement of PAPR reduction of orthogonal frequency division multiplexing (OFDM) signal using amplitude clipping & filtering based design. Note that OFDM is one of the well adept multi-carrier…
This paper presents performance analysis of an adaptive peak cancellation method to reduce the high peak-toaverage power ratio (PAPR) for OFDM systems, while keeping the out-of-band (OoB) power leakage as well as an in-band distortion power…
Neural networks are used for channel decoding, channel detection, channel evaluation, and resource management in multi-input and multi-output (MIMO) wireless communication systems. In this paper, we consider the problem of finding precoding…
Orthogonal frequency division multiplexing (OFDM) has proven itself as an effective multi-carrier digital communication technique. In recent years the interest in optical OFDM has grown significantly, due to its spectral efficiency and…
The peak power problem in multicarrier waveforms is well-known and imposes substantial limitations on wireless communications. As the quest for investigation of enabling technologies for the next generation of wireless communication systems…
We study the peak-to-average power ratio (PAPR) problem in orthogonal frequency-division multiplexing (OFDM) systems. In conventional clipping and filtering based PAPR reduction techniques, clipping noise is allowed to spread over the whole…
Mixed-numerology transmission is proposed to support a variety of communication scenarios with diverse requirements. However, as the orthogonal frequency division multiplexing (OFDM) remains as the basic waveform, the peak-to average power…
Massive MIMO requires a large number of antennas and the same amount of power amplifiers (PAs), one per antenna. As opposed to 4G base stations, which could afford highly linear PAs, next-generation base stations will need to use…
Spectral efficiency is a key design issue for all wireless communication systems. Orthogonal frequency division multiplexing (OFDM) is a very well-known technique for efficient data transmission over many carriers overlapped in frequency.…
Integrated Sensing and Communications (ISAC) has garnered significant attention as a promising technology for next-generation wireless and vehicular communications. Among candidate waveforms, Orthogonal Frequency Division Multiplexing…