Related papers: Buckling of residually stressed cylindrical tubes …
This paper addresses testing of compressed structures, such as shells, that exhibit catastrophic buckling and notorious imperfection sensitivity. The central concept is the probing of a loaded structural specimen by a controlled lateral…
We investigate non-linear elastic deformations in the phase field crystal model and derived amplitude equations formulations. Two sources of non-linearity are found, one of them based on geometric non-linearity expressed through a finite…
We derive a one-dimensional (1d) model for the analysis of bulging or necking in an inflated hyperelastic tube of {\it finite wall thickness} from the three-dimensional finite elasticity theory by applying the dimension reduction…
When stretched uniaxially, a thin elastic sheet may exhibit buckling. The occurrence of buckling depends on the geometrical properties of the sheet and the magnitude of the applied strain. Here we show that an elastomeric sheet initially…
Galactic bars are unstable to a vertical buckling instability which heats the disk and in some cases forms a boxy/peanut shaped bulge. We analyze the buckling instability as an application of classical Euler buckling followed by nonlinear…
We study elastic ribbons subject to large, tensile pre-stress confined to a central region within the cross-section. These ribbons can buckle spontaneously to form helical shapes, featuring regions of alternating chirality (phases) that are…
Turing patterns emerge from a spatially uniform state following a linear instability driven by diffusion. Features of the eventual pattern (stabilized by non-linearities) are already present in the initial unstable modes. On a uniform flat…
A cantilever beam under axial flow, confined or not, is known to develop self-sustained oscillations at sufficiently large flow velocities. In recent decades, the analysis of this archetypal system has been mostly pursued under linearized…
Stationary whirling of slender and homogeneous (continuous) elastic shafts rotating around their axis, with pin-pin boundary condition at the ends, is revisited by considering the complete deformations in the cross section of the shaft. The…
The thermodynamic dislocation theory developed for non-uniform plastic deformations is used here to simulate the stress-strain curves for crystals subjected to anti-plane shear-controlled load reversal. We show that the presence of the…
Incremental stiffness characterizes the variation of a material's force response to a small deformation change. Typically materials have an incremental stiffness that is fixed and positive, but recent technologies, such as super-lenses, low…
It is well known that an annular sheet could wrinkle as a result of axisymmetric tensile loads applied at the edges. In this system, regions under compression appear due to Poisson effect in the azimuthal direction yielding an incompatible…
This work investigates the morphological stability of a soft body composed of two heavy elastic layers, attached to a rigid surface and subjected only to the bulk gravity force. Using theoretical and computational tools, we characterize the…
We study the necking of a filament of complex fluid or soft solid subject to uniaxial tensile stretching, under conditions of constant imposed stress and force, by means of linear stability analysis and nonlinear simulations. We demonstrate…
A crystal plasticity theory was developed for use in simulations of dynamic loading at high pressures and strain rates. At pressures of the order of the bulk modulus, compressions o(100%) may be induced. At strain rates o(10^9)/s or higher,…
The archetypal instability of a structure is associated with the eponymous Euler beam, modeled as an inextensible curve which exhibits a supercritical bifurcation at a critical compressive load. In contrast, a soft compressible beam is…
When twisting a strip of paper or acetate under high longitudinal tension, one observes, at some critical load, a buckling of the strip into a regular triangular pattern. Very similar triangular facets have recently been observed in…
The production of mechanical stresses in living organisms largely relies on localized, force-generating active units embedded in filamentous matrices. Numerical simulations of discrete fiber networks with fixed boundaries have shown that…
A linear stability analysis of the hydrodynamic equations with respect to the homogeneous cooling state is carried out to identify the conditions for stability of a granular gas of rough hard spheres. The description is based on the results…
The development of turbulent mixing layers can be altered by the application of anisotropic strain rates, potentially arising from radial motion in convergent geometry or movement through non-uniform geometry. Previous closure models and…