Related papers: Uncertainty minimization in electronic stopping cr…
Electronic stopping cross section of tungsten for light ions was experimentally measured in a wide energy interval (20 to 6000 keV for protons and 50 to 9000 keV for helium) in backscattering and transmission geometries. The measurements…
Helium atom scattering (HAS) is a well established technique for examining the surface structure and dynamics of materials at atomic sized resolution. The HAS technique Helium spin-echo spectroscopy opens up the possibility of compressing…
The objective of electrical impedance tomography is to deduce information about the conductivity inside a physical body from electrode measurements of current and voltage at the object boundary. In this work, the unknown conductivity is…
We compare transmission He ion microscopy (HIM) to transmission electron microscopy (TEM) of graphene support films. We present spot transmission patterns that compare with scattering and range of ions in materials (SRIM) predictions, and…
In the following work, we described the problems of porosity analysis of cement materials using backscattered electron images. We noticed that despite its great utility, the overflow porosity segmentation method allows for the introduction…
A precise measurement of the total cross section and the coulomb scattering at the LHC requires the observation of elastically scatteredparticles at extremely small angles (14 microrad, -t < 0.01 GeV**2 for the first case; 3 microrad,…
Reverberation chambers (RCs) were recently reported as a low-cost alternative to anechoic chambers (ACs) to perform radar cross-section (RCS) pattern measurements. The method consists of using transmitting and receiving antennas pointing…
Atmospheric lidar observations provide a unique capability to directly observe the vertical column of cloud and aerosol scattering properties. Detector and solar background noise, however, hinder the ability of lidar systems to provide…
The OLYMPUS experiment measured the cross-section ratio of positron-proton elastic scattering relative to electron-proton elastic scattering to look for evidence of hard two-photon exchange. To make this measurement, the experiment…
The stopping cross sections S (E) of silicon for protons and alpha particles have been measured over the velocity range 0.3-1.2 MeV/u from a SIMOX target using the Rutherford Backscattering Spectrometry (RBS) with special emphasis put on…
We describe a method of white-beam inelastic neutron scattering for improved measurement efficiency. The method consists of matrix inversion and selective extraction. The former is to resolve each incident energy component from the…
Neutral helium atom microscopy is a novel microscopy technique that offers strictly surface-sensitive, non-destructive imaging. Several experiments have been published in recent years where images are obtained by scanning a helium beam spot…
A scanning helium microscope typically utilises a thermal energy helium atom beam, with an energy and wavelength (<100 meV, ~0.05 nm) particularly sensitive to surface structure. An angular detector stage for a scanning helium microscope is…
We present two backscattering polarimetric scanning setups based on point-illumination schemes, that are designed to probe the optical properties of subsurface media. We describe their advantages and limitations, characterize their…
We describe a self calibrating optical technique that allows to perform absolute measurements of scattering cross sections for the light scattered at extremely small angles. Very good performances are obtained by using a very simple optical…
The stability and emissivity of the online calibration blackbody used in high-precision infrared remote sensing detectors in extreme environments are the primary limiting factors for their measurement accuracy. Due to the limitations of…
Electron energy loss spectroscopy is consolidating as a powerful tool to explore electronic (as well as vibrational) excitations of matter, including molecules. Performed in a scanning transmission electron microscope, this technique is…
A new experimental equipment allowing to study the sputtering induced by ion beam irradiation is presented. The sputtered particles are collected on a catcher which is analyzed in situ by Auger electron spectroscopy without breaking the…
Pattern matching between target electron backscatter patterns (EBSPs) and dynamically simulated EBSPs was used to determine the pattern centre (PC) and crystal orientation, using a global optimisation algorithm. Systematic analysis of error…
The technique of High Spectral Resolution Lidar (HSRL) for atmospheric monitoring allows the determination of the aerosol to molecular ratio and can be used in UHECR Observatories using air fluorescence telescopes. By this technique a more…