Related papers: Complexity-Scalable Near-Optimal Transceiver Desig…
Due to its attractive properties, generalized frequency division multiplexing (GFDM) is recently being discussed as a candidate waveform for the fifth generation of wireless communication systems (5G). GFDM is introduced as a generalized…
Efficient implementation of massive multiple-input-multiple-output (MIMO) transceivers is essential for the next-generation wireless networks. To reduce the high computational complexity of the massive MIMO transceiver, in this paper, we…
High resolution analog to digital converters (ADCs) are conventionally used at the receiver terminals to store an accurate digital representation of the received signal, thereby allowing for reliable decoding of transmitted messages.…
Multi-antenna precoding effectively mitigates the interference in wireless networks. However, the resultant performance gains can be significantly compromised in practice if the precoder design fails to account for the inaccuracy in the…
In the evolving landscape of 5G and 6G networks, the demands extend beyond high data rates, ultra-low latency, and extensive coverage, increasingly emphasizing the need for reliability. This paper proposes an ultra-reliable multiple-input…
Neural networks have been applied to the physical layer of wireless communication systems to solve complex problems. In millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, hybrid precoding has been considered as…
In this paper, we consider dynamic precoder/decorrelator optimization for multimedia streaming in MIMO interference networks. We propose a truly cross-layer framework in the sense that the optimization objective is the application level…
This paper presents new results on linear transceiver designs in a multiple-input-multiple-output (MIMO) link. By considering the minimal total mean-square error (MSE) criterion, we prove that the robust optimal linear transceiver design…
Physical layer network coding (PNC) has been studied to serve wireless network MIMO systems with much lower backhaul load than approaches such as Cloud Radio Access Network (Cloud-RAN) and coordinated multipoint (CoMP). In this paper, we…
As a typical example of bandwidth-efficient techniques, bit-interleaved coded modulation with iterative decoding (BICM-ID) provides desirable spectral efficiencies in various wireless communication scenarios. In this paper, we carry out a…
Reconfigurable massive multiple-input multiple-output (RmMIMO), as an electronically-controlled fluid antenna system, offers increased flexibility for future communication systems by exploiting previously untapped degrees of freedom in the…
In this paper, a novel transmissive reconfigurable meta-surface (RMS) transceiver enabled multi-tier computing network architecture is proposed for improving computing capability, decreasing computing delay and reducing base station (BS)…
This paper addresses the joint transceiver design for downlink multiuser multiple-input multiple-output (MIMO) systems, with imperfect channel state information (CSI) at the base station (BS) and mobile stations (MSs). By incorporating…
Switch-based hybrid network is a promising implementation for beamforming in large-scale millimetre wave (mmWave) antenna arrays. By fully exploiting the sparse nature of the mmWave channel, such hybrid beamforming reduces complexity and…
The integrated sensing and communication (ISAC) system under multi-input multi-output (MIMO) architecture achieves dual functionalities of sensing and communication on the same platform by utilizing spatial gain, which provides a feasible…
In this paper, we present a low-complexity algorithm for detection in high-rate, non-orthogonal space-time block coded (STBC) large-MIMO systems that achieve high spectral efficiencies of the order of tens of bps/Hz. We also present a…
Hybrid beamforming (HB) architectures are attractive for wireless communication systems with large antenna arrays because the analog beamforming stage can significantly reduce the number of RF transceivers and hence power consumption. In HB…
In this paper, we firstly exploit the inter-user interference (IUI) and inter-cell interference (ICI) as useful references to develop a robust transceiver design based on interference alignment for a downlink multi-user multi-cell…
Achieving high spectral efficiency in realistic massive multi-user (MU) multiple-input multiple-output (MIMO) wireless systems requires computationally-complex algorithms for data detection in the uplink (users transmit to base-station) and…
Employing low resolution analog-to-digital converters in massive multiple-input multiple-output (MIMO) has many advantages in terms of total power consumption, cost and feasibility of such systems. However, such advantages come together…