Related papers: DualMS: Implicit Dual-Channel Minimal Surface Opti…
We model a microchannel cooling system and consider the optimization of its shape by means of shape calculus. A three-dimensional model covering all relevant physical effects and three reduced models are introduced. The latter are derived…
Mimicking vascular systems in living beings, designers have realized microvascular composites to achieve thermal regulation and other functionalities, such as electromagnetic modulation, sensing, and healing. Such material systems avail…
Periodic fin structures are often employed to enhance heat transfer in compact cooling solutions and heat exchangers. Adjoint-based optimization methods are able to further increase the heat transfer by optimizing the fin geometry. However,…
Integrated electricity and gas systems are constructed to facilitate the gas-fired generation, and the distributed operation of these integrated systems have received much attention due to the increased emphasis on data security and privacy…
Dynamic Metasurface Antennas (DMAs) constitute a promising solution for extremely large antenna arrays, requiring lower power consumption and reduced hardware cost as compared to conventional phased arrays. In this paper, we consider a…
We study the finite-temperature dynamics of thin elastic sheets in a single-clamped cantilever configuration. This system is known to exhibit a tilt transition at which the preferred mean plane of the sheet shifts from horizontal to a plane…
The design of fluid channel structures of reactors or separators of chemical processes is key to enhancing the mass transfer processes inside the devices. However, the systematic design of channel topological structures is difficult for…
An innovative and accurate dynamic Compact Thermal Model extraction method is proposed for multi-chip power electronics systems. It accounts for thermal coupling between multiple heat sources. Transient electro-thermal coupling can easily…
We propose a two-level structural optimization method for obtaining an approximate optimal shape of piecewise developable surface without specifying internal boundaries between surface patches. The condition for developability of a…
We provide some general theoretical results to guide the optimization of transverse hydrodynamic phenomena in superhydrophobic channels. Our focus is on the canonical micro- and nanofluidic geometry of a parallel-plate channel with an…
This work considers the problem of energy efficiency maximization in a RIS-based communication link, subject to not only the conventional maximum power constraints, but also additional constraints on the maximum exposure to electromagnetic…
Reconfigurable intelligent surfaces (RISs) are able to provide passive beamforming gain via low-cost reflecting elements and hence improve wireless link quality. This work considers two-way passive beamforming design in RIS-aided frequency…
Closed-loop shallow geothermal systems are one of the key technologies for decarbonizing the residential heating and cooling sector. The primary type of these systems involves vertical borehole heat exchangers (BHEs). During the planning…
The modeling and simulation of heat source trajectories through phase-change materials is a relevant problem both for space exploration and for terrestrial climate research, among other fields. In space, the DLR and NASA are both interested…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
This work presents the application of density-based topology optimisation to the design of three-dimensional heat sinks cooled by natural convection. The governing equations are the steady-state incompressible Navier-Stokes equations…
Infrared thermography faces persistent challenges in temperature accuracy due to material emissivity variations, where existing methods often neglect the joint optimization of radiometric calibration and image degradation. This study…
Since hydrogen has many advantages (e.g., free pollution, extensive sources, convenient storage and transportation), hydrogen-based multi-energy systems (HMESs) have received wide attention. However, existing works on the optimal operation…
A consistent description of simultaneous heat and particle transport, including cross effects, and the associated entropy balance is given in the framework of a deterministic dynamical system. This is achieved by a multibaker map where,…
Multi-machine empirical scaling predicts an extremely narrow heat exhaust layer in future high magnetic field tokamaks, producing high power densities that require mitigation. In the experiments presented, the width of this exhaust layer is…