Related papers: Limited-Resolution Hybrid Analog-Digital Precoding…
Spectrally efficient multi-antenna wireless communication systems are a key challenge as service demands continue to increase. At the same time, powering up radio access networks is facing environmental and regulation limitations. In order…
The potential of using millimeter-wave (mmWave) to encounter the current bandwidth shortage has motivated packing more antenna elements in the same physical size which permits the advent of massive multiple-input-multiple-output (MIMO) for…
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) with hybrid precoding is a promising technique for the future 5G wireless communications. Due to a large number of antennas but a much smaller number of radio frequency…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
Using multiple-input multiple-output (MIMO) with orthogonal frequency division multiplexing (OFDM) for integrated sensing and communication (ISAC) has attracted considerable attention in recent years. While most existing works focus on…
Large propagation path loss and limited scattering of millimeter wave (mmwave) channels create new challenges for physical layer signal processing. Hence, in this article, we propose a photonic hybrid precoding model for mmwave…
Hybrid analog and digital beamforming is a promising candidate for large-scale mmWave MIMO systems because of its ability to significantly reduce the hardware complexity of the conventional fully-digital beamforming schemes while being…
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems have been considered as one of the primary candidates for the fifth generation (5G) and beyond 5G wireless communication networks to satisfy the ever-increasing…
Employing low-resolution analog-to-digital converters (ADCs) for millimeter wave receivers with large antenna arrays provides opportunity to efficiently reduce power consumption of the receiver. Reducing ADC resolution, however, results in…
The use of low-precision analog-to-digital converters (ADCs) is a low-cost and power-efficient solution for a millimeter wave (mmWave) multiple-input multiple-output (MIMO) system operating at sampling rates higher than a few Gsample/sec.…
In this paper, we propose a two-stage analog combining architecture for millimeter wave (mmWave) communications with hybrid analog/digital beamforming and low-resolution analog-to-digital converters (ADCs). We first derive a two-stage…
In this paper, we investigate the energy-efficient hybrid precoding design for integrated multicast-unicast millimeter wave (mmWave) system, where the simultaneous wireless information and power transform is considered at receivers. We…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…
Coarsely quantized MIMO signalling methods have gained popularity in the recent developments of massive MIMO as they open up opportunities for massive MIMO implementation using cheap and power-efficient radio-frequency front-ends. This…
The emerging memristor crossbar array based computing circuits exhibit computing speeds and energy efficiency far surpassing those of traditional digital processors. This type of circuits can complete high-dimensional matrix operations in…
In multiple-antenna communications, as bandwidth and modulation order increase, system components must work with demanding tolerances. In particular, high resolution and high sampling rate analog-to-digital converters (ADCs) are often…
This paper studies the problem of linear precoding for multiple-input multiple-output (MIMO) communication channels employing finite-alphabet signaling. Existing solutions typically suffer from high computational complexity due to costly…
We consider a hardware-impaired multi-cell Rician faded massive multi-input multi-output (mMIMO) system with two-layer pilot decontamination precoding, also known as large-scale fading precoding (LSFP). Each BS is equipped with a flexible…
Consider the following problem: A multi-antenna base station (BS) sends multiple symbol streams to multiple single-antenna users via precoding. However, unlike conventional multiuser precoding, the transmitted signals are subjected to…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…