Related papers: Edge Exposure as the Trigger for Structural Instab…
Cubic gauche polynitrogen (cg-N) is an attractive high-energy density material. However, high-pressure synthesized cg-N will decompose at low-pressure and cannot exist at ambient conditions. Here, the stabilities of cg-N surfaces with and…
Stabilizing nitrogen-rich compound crystals under conventional conditions is a key issue in the development and application of high-energy density materials (HEDMs). Herein, a two-dimensional double-layer interlocked Li4(N5)2 nitrogen-rich…
Black phosphorus nitrogen (BP-N) is an attractive high-energy-density material. However, high-pressure synthesized BP-N will decompose at low-pressure and cannot be quenched to ambient conditions. Finding a method to stabilize it at 0 GPa…
It is shown how the combination of atomic deposition and nonlinear diffusion may lead, below a critical temperature, to the growth of nonuniform layers on a substrate. The dynamics of such a system is of the Cahn-Hilliard type, supplemented…
Thanks to its high refractive index contrast, band gap and polarization mismatch compared to GaN, In0.17Al0.83N layers lattice-matched to GaN are an attractive solution for applications such as distributed Bragg reflectors, ultraviolet…
A growing or compressed thin elastic sheet adhered to a rigid substrate can exhibit a buckling instability, forming an inward hump. Our study shows that the strip morphology depends on the delicate balance between the compression energy and…
Using a comprehensive structure search and high-throughput first-principles calculations of 1483 compounds, this study presents the phase diagram of Lu-H-N. The formation energy landscape of Lu-H-N was derived and utilized to assess the…
The structures, cohesive energies and HOMO-LUMO gaps of graphene nanoflakes and corresponding polycyclic aromatic hydrocarbons for a large variety of size and topology are investigated at the density functional based tight-binding level.…
Two-dimensional alloys of carbon and nitrogen represent an urgent interest due to prospective applications in nanomechanical and optoelectronic devices. Stability of these chemical structures must be understood as a function of their…
Liquid crystal elastomers (LCEs) are soft phase-changing solids that exhibit large reversible contractions upon heating, Goldstone-like soft modes and resultant microstructural instabilities. We heat a planar LCE slab to isotropic, clamp…
A new extended solid nitrogen, referred to post-layered-polymeric nitrogen (PLP-N), was observed by further heating the layered-polymeric nitrogen (LP-N) to above 2300 K at 161 GPa. The new phase is found to be very transparent and exhibits…
Non-conservative loads of the follower type are usually believed to be the source of dynamic instabilities such as flutter and divergence. It is shown that these instabilities (including Hopf bifurcation, flutter, divergence, and…
Interaction between hydrogen (H) and metals is central to many materials problems of scientific and technological importance. Chief among them is the development of H storage and H-resistant materials. H segregation or trapping at lattice…
Structural lubricity arises typically at incommensurate, well-defined dry contacts where short-range elastic instability is significantly mitigated. However, under ambient conditions, airborne molecules adsorb onto solid surfaces, forming…
This paper considers the effect of electrostatics on the stability of a charged membrane. We show that at low ionic strength and high surface charge density, repulsion between charges on the membrane renders it unstable to the formation of…
Organic$-$inorganic hybrid Ruddlesden$-$Popper perovskites (HRPPs) have gained much attention for optoelectronic applications due to their high moisture resistance, good processibility under ambient conditions, and long functional…
A confined incompressible elastic film does not deform uniformly when subjected to adhesive interfacial stresses but with undulations which have a characteristic wavelength scaling linearly with the thickness of the film. In the classical…
The Helfrich-Hurault (HH) elastic instability is a well-known mechanism behind patterns that form as a result of strain upon liquid crystal systems with periodic ground states. In the HH model, layered structures undulate and buckle in…
Recently, the existence of robust three-dimensional light bullets (LBs) was predicted theoretically in the output of a laser coupled to a distant saturable absorber. In this manuscript, we analyze the stability and the range of existence of…
Employing ab initio calculations, we discuss chemical, mechanical, and dynamical stability of MoN-TaN solid solutions together with cubic-like MoN/TaN superlattices, as another materials design concept. Hexagonal-type structures based on…