Related papers: Balloon regime: Drop elasticity leads to complete …
The breakup of water droplets when exposed to high-speed gas flows is investigated using both high-magnification shadowgraphy experiments as well as fully three-dimensional numerical simulations, which account for viscous as well as…
In this study, we perform a numerical analysis of the instability of a ligament in shear flow and investigate the effects of air-liquid shear on the growth rate of the ligament interface, breakup time, and droplet diameter formed by the…
A weakly deformable droplet impinging on a rigid surface rebounds if the surface is intrinsically hydrophobic or if the gas film trapped underneath the droplet is able to keep the interfaces from touching. A simple, physically motivated…
The stretching of viscoelastic polymer solutions close to break-up can create attached drops on a filament, whose properties and dynamics are little understood. The stretching of capillary bridges and the consecutive filament, until its…
The breakup of thinning (stretching) liquid ligaments is strongly influenced by localized perturbations arising from impurities or suspended particles. Using numerical simulations and analytical modelling, we investigate the role of a solid…
We study the collapse of an axisymmetric liquid filament both analytically and by means of a numerical model. The liquid filament, also known as ligament, may either collapse stably into a single droplet or break up into multiple droplets.…
We study pattern formation during tensile deformation of confined viscoelastic layers. The use of a model system (PDMS with different degrees of crosslinking) allows us to go continuously from a viscous liquid to an elastic solid. We…
A liquid jet can stably bounce off a sufficiently soft gel, by following the contour of the dimple created upon impact. This new phenomenon is insensitive to the wetting properties of the gels and was observed for different liquids over a…
When a liquid drop falls on a solid substrate, the air layer in between them delays the occurrence of liquid--solid contact. For impacts on smooth substrates, the air film can even prevent wetting, allowing the drop to bounce off with…
The impact and rupture of water-filled balloons upon a flat, rigid surface is studied experimentally, for which three distinct stages of the flow are observed. Due to the impact, waves are formed on the balloon's surface for which the…
A ball dropped from a given height onto a surface, will bounce repeatedly before coming to rest. A ball bouncing on a thick plate will behave very differently than a ball bouncing off the thin lid of a container. For a plate with a fixed…
We investigate the dynamics of drop impact on a thin liquid film at short times in order to identify the mechanisms of splashing formation. Using numerical simulations and scaling analysis, we show that the splashing formation depends both…
This study performed a numerical analysis of the deformation and breakup of a liquid ligament with various disturbances on the interface in shear flow. The shear flow generates a three-dimensional flow and vortices around the liquid…
Liquid drops on soft solids generate strong deformations below the contact line, resulting from a balance of capillary and elastic forces. The movement of these drops may cause strong, potentially singular dissipation in the soft solid.…
Rigid superhydrophobic materials have the ability to repel millimetric water drops, in typically 10 ms. Yet, most natural water-repellent materials can be deformed by impacting drops. To test the effect of deformability, we perform impacts…
We investigate the wrinkling dynamics of an elastic filament immersed in a viscous fluid submitted to compression at a finite rate with experiments and by combining geometric nonlinearities, elasticity, and slender body theory. The drag…
The dynamic of contact formation between soft materials immersed in a fluid is accompanied by fluid drainage and elastic deformation. As a result, controlling the coupling between lubrication pressure and elasticity provides strategies to…
Thin, viscous liquid films subjected to impact events can deform. Here we investigate free surface oil film deformations that arise due to the air pressure buildup under the impacting and rebouncing water drops. Using Digital Holographic…
In this work, we analyse the stick-slip motion of a soft elastomeric block on a smooth, hard surface under the application of shear, which is induced by a puller moving at a steady velocity. The frictional stress is generated by make-break…
A filament of liquid is usually unstable and breaks up into small droplets, while a filament of polymer solution is known to be quite stable against such instability, and they form a stable configuration of filament connecting two spherical…