Related papers: ALICE ITS2: overview and performance
The ATLAS collaboration will replace its tracking detector with new all silicon pixel and strip systems. This will allow to cope with the higher radiation and occupancy levels expected after the 5-fold increase in the luminosity of the LHC…
During the Long Shutdown 3 (LS3, scheduled 2026-2030), the innermost 3 layers (Inner Barrel, or IB) of the present ALICE ITS2 will be replaced with large-area, flexible, stitched CMOS 65 nm sensors, arranged in 2 half-barrels of 3…
For the High Luminosity upgrade of the Large Hadron Collider the current ATLAS Inner Detector will be replaced by an all-silicon Inner Tracker. The pixel detector will consist of five barrel layers and a number of rings, resulting in about…
The ATLAS Inner Tracker, the future innermost part of the ATLAS detector, is an all-silicon tracker composed of pixel and strip modules, designed to cope with the extreme conditions expected during High-Luminosity LHC runs. Thorough testing…
In view of the high luminosity phase of the LHC (HL-LHC) to start operation around 2026, a major upgrade of the tracker system for the ATLAS experiment is in preparation. The expected neutron equivalent fluence of up to 2.4 * 1e16 1 MeV…
The two innermost layers of the ALICE inner tracking system are instrumented with silicon pixel detectors. Single chip assembly prototypes of the ALICE pixels have been tested in high energy particle beams at the CERN SPS. Detection…
Following the Phase-II upgrade during Long Shutdown (LS3), the LHC aims to reach a peak instantaneous luminosity of $7.5\times 10^{34}$cm$^{-2}$s$^{-1}$, which corresponds to an average of around 200 inelastic proton-proton collisions per…
For the Inner Tracking System 3 (ITS3) upgrade, the ALICE experiment at CERN requires monolithic active pixel sensors of dimensions up to 97~mm$\,\times\,$266~mm, occupying a large fraction of a 300 mm wafer. To manufacture such a…
The Silicon Strip Detector (SSD) is a fundamental part of the Inner Tracking System (ITS) for the ALICE experiment. Since the early phase of proton-proton collisions at LHC, the SSD is fully operational and participating in the charged…
In the upcoming LHC Run 3, starting in 2021, the upgraded Time Projection Chamber (TPC) of the ALICE experiment will record minimum bias Pb-Pb collisions in a continuous readout mode at an interaction rate up to 50 kHz. This corresponds to…
In LHC Run 3, ALICE will increase the data taking rate significantly to continuous readout of 50 kHz minimum bias Pb-Pb collisions. The reconstruction strategy of the online offline computing upgrade foresees a first synchronous online…
The high $P_T$ trigger capabilities of the ALICE inner tracking system (ITS) as a standalone detector have been investigated. Since the high $P_T$ charged particles mostly lead to the linear trajectories within this ITS sector, it is…
The design, construction, and commissioning of the ALICE Time-Projection Chamber (TPC) is described. It is the main device for pattern recognition, tracking, and identification of charged particles in the ALICE experiment at the CERN LHC.…
The Time Projection Chamber is the main tracking and particle identification detector of the ALICE experiment. The high luminosities delivered by the CERN LHC in Run 2 (2015-2018) posed new challenges in terms of detector performance and…
Charged-particle reconstruction is a fundamental part of the event reconstruction in modern multi-purpose high-energy physics detectors. This paper describes the algorithms used to reconstruct charged particles and primary vertices with the…
ALICE is the dedicated heavy-ion experiment at the CERN Large Hadron Collider (LHC). Its main tracking and particle-identification detector is a large volume Time Projection Chamber (TPC). The TPC has been designed to perform well in the…
The Pixel Detector of the ATLAS experiment has shown excellent performance during the whole Run-1 of LHC. Taking advantage of the long shutdown, the detector was extracted from the experiment and brought to surface, to equip it with new…
Monolithic Active Pixel Sensors (MAPS) combine the sensing part and the front-end electronics in the same silicon layer, making use of CMOS technology. Profiting from the progresses of this commercial process, MAPS have been undergoing…
In view of Run 4 at the LHC, presently scheduled from 2029 onwards, ALICE is pursuing several upgrades to further extend its physics reach. In order to improve heavy-flavor hadron and dielectron measurements which rely on secondary…
Knowledge of the material in the ATLAS inner tracking detector is crucial in understanding the reconstruction of charged-particle tracks, the performance of algorithms that identify jets containing b-hadrons and is also essential to reduce…