Related papers: Beamforming with Joint Phase and Time Array: Syste…
Analog/digital hybrid beamforming architectures with large-scale antenna arrays have been widely considered in millimeter wave (mmWave) communication systems because they can address the tradeoff between performance and hardware efficiency…
Dynamic metasurface antennas (DMAs) beamform through low-powered components that enable reconfiguration of each radiating element. Previous research on a single-user multiple-input-single-output (MISO) system with a dynamic metasurface…
Josephson Parametric Amplifiers (JPAs) are key components in quantum information processing due to their ability to amplify weak quantum signals with near-quantum-limited noise performance. This is essential for applications such as qubit…
The evolution of wireless communication systems towards millimeter-wave ($30-100$ GHz) and sub-THz ($>100$ GHz) frequency bands highlighted the need for accurate and fast beam management and a proactive link-blockage prediction in…
The evolution of programmable metasurfaces (PM) from passive beamforming to active information transmission marks a paradigm shift for next-generation wireless systems. However, this transition is hindered by fundamental limitations in…
In order to cope with the large path-loss exponent of mm-Wave channels, a high beamforming gain is needed. This can be achieved with small hardware complexity and high hardware power efficiency by Hybrid Digital-Analog (HDA) beamforming,…
Broadband beamforming is a technique to obtain the signal with a wide range of frequencies. It maintains the signal integrity and spatial selectivity over frequencies. This is important in several applications such as microphone array,…
In this paper, we consider multigroup multicast transmissions with different types of service messages in an overloaded multicarrier system, where the number of transmitter antennas is insufficient to mitigate all inter-group interference.…
Beamforming is traditionally associated with coherent summation of signals from antenna elements of the same polarization, here referred to as single polarization beamforming (SPBF). In this paper we focus on a new method, called dual…
Frequency-hopping (FH) joint radar-communications (JRC) can offer excellent security for integrated sensing and communication systems. However, existing JRC schemes mainly embed information using only the sub-pulse frequencies and hence the…
In 5G networks, a Radio over Fiber architecture utilizing multicore fibers can be adopted for the transmission of mmwave signals feeding phased array antennas. The mmwave signals undergo phase shifts imposed by optical true time delay…
The decadal research in integrated true-time-delay arrays have seen organic growth enabling realization of wideband beamformers for large arrays with wide aperture widths. This article introduces highly reconfigurable delay elements…
This paper proposes a scheme for the envisioned sixth-generation (6G) ultra-massive Machine Type Communications(umMTC). In particular, wireless power transfer (WPT) assisted communication is deployed in non-orthogonal multiple access (NOMA)…
Joint radar-communications (JRC) is considered to be a vital technology in deploying the next generation systems, since its useful in decongestion of the radio frequency (RF) spectrum and utilising the same hardware resources for dual…
Time Reversal (TR) has been proposed as a competitive precoding strategy for low-complexity devices, relying on ultra-wideband waveforms. This transmit processing paradigm can address the need for low power and low complexity receivers,…
This paper studies the joint optimization problem of two-way relay beamforming, the receiver power splitting (PS) ratio as well as the transmit power at the sources to maximize the achievable sum-rate of a simultaneous wireless information…
We propose beam division multiple access (BDMA) with per-beam synchronization (PBS) in time and frequency for wideband massive multiple-input multiple-output (MIMO) transmission over millimeter-wave (mmW)/Terahertz (THz) bands. We first…
We propose a hybrid architecture that integrates RF (i.e., sub-6 GHz) and millimeter wave (mmWave) technologies for 5G cellular systems. In particular, communications in the mmWave band faces significant challenges due to variable channels,…
The requirement of high data-rate in the fifth generation wireless systems (5G) calls for the ultimate utilization of the wide bandwidth in the mmWave frequency band. Researchers seeking to compensate for mmWave's high path loss and to…
Millimeter wave (mmWave) will play a significant role as a 5G candidate in facing the growing demand of enormous data rate in the near future. The conventional mmWave standard, IEEE 802.11ad, considers establishing only one mmWave link in…