Related papers: One-Bit Sigma-Delta DFRC Waveform Design: Using Qu…
Leveraging the available millimeter wave spectrum will be important for 5G. In this work, we investigate the performance of digital beamforming with low resolution ADCs based on link level simulations including channel estimation, MIMO…
We present a novel approach to the problem of dual-functional radar and communication (DFRC) waveform design with adjustable peak-to-average power ratio (PAPR), while minimizing the multi-user communication interference and maintaining a…
Reconfigurable intelligent surface (RIS) is a promising technology for 6G networks owing to its superior ability to enhance the capacity and coverage of wireless communications by smartly creating a favorable propagation environment. In…
In this paper, we study Full Duplex (FD) Multiple-Input Multiple-Output (MIMO) radios for simultaneous data communication and control information exchange. Capitalizing on a recently proposed FD MIMO architecture combining digital transmit…
We consider the problem of channel estimation for uplink multiuser massive MIMO systems, where, in order to significantly reduce the hardware cost and power consumption, one-bit analog-to-digital converters (ADCs) are used at the base…
Distributed integrated sensing and communication (D-ISAC) enables multiple spatially distributed nodes to cooperatively perform sensing and communication. However, achieving coherent cooperation across distributed nodes is challenging due…
As a next-generation wireless technology, the in-band full-duplex (IBFD) transmission enables simultaneous transmission and reception of signals over the same frequency, thereby doubling spectral efficiency. Further, a continuous up-scaling…
Recent years have witnessed growing interest in reduced cost radar systems operating with low power. Multiple-input multiple-output (MIMO) radar technology is known to achieve high performance sensing by probing with multiple orthogonal…
Digital modulation schemes such as PMCW have recently attracted increasing attention as possible replacements for FMCW modulation in future automotive radar systems. A significant obstacle to their widespread adoption is the expensive and…
Multiple-input multiple-output (MIMO) wireless systems conventionally use high-resolution analog-to-digital converters (ADCs) at the receiver side to faithfully digitize received signals prior to digital signal processing. However, the…
In this letter, we consider the coexistence and spectrum sharing between downlink multi-user multiple-input-multiple-output (MU-MIMO) communication and a MIMO radar. For a given performance requirement of the downlink communication system,…
We investigate massive multiple-input-multiple output (MIMO) uplink systems with 1-bit analog-to-digital converters (ADCs) on each receiver antenna. Receivers that rely on 1-bit ADC do not need energy-consuming interfaces such as automatic…
This paper develops novel deep learning-based architectures and design methodologies for an orthogonal frequency division multiplexing (OFDM) receiver under the constraint of one-bit complex quantization. Single bit quantization greatly…
Adopting one-bit analog-to-digital convertors (ADCs) for massive multiple-input multiple-output (MIMO) implementations has great potential in reducing the hardware cost and power consumption. However, distortions caused by quantization…
Quantized massive multiple-input-multiple-output (MIMO) systems are gaining more interest due to their power efficiency. We present a new precoding technique to mitigate the multi-user interference and the quantization distortions in a…
Integrated sensing and communication (ISAC) has been widely recognized as one of the key technologies for 6G wireless networks. In this paper, we focus on the waveform design of ISAC system, which can realize radar sensing while also…
In this paper, we investigate secure transmission in a massive multiple-input multiple-output (MIMO) system adopting low-resolution digital-to-analog converters (DACs). Artificial noise (AN) is deliberately transmitted simultaneously with…
The optimization of the transmit parameters (power allocation and steering vectors) for the MIMO BC under general linear constraints is treated under the optimal DPC coding strategy and the simple suboptimal linear zero-forcing beamforming…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
Hybrid beamforming is key to achieving energy-efficient 5G wireless networks equipped with massive amount of antennas. Low-resolution data converters bring yet another degree of freedom to energy efficiency for the state-of-the-art 5G…