Related papers: Electrostatic Clutch-Based Mechanical Multiplexer …
This paper presents the mechatronic design, dynamic modeling, and experimental validation of a three-degree-of-freedom (3-DOF) micro parallel robot featuring a prismatic-spherical (3PS) topology actuated by three Hydraulically Amplified…
Tendon-driven hand orthoses have advantages over exoskeletons with respect to wearability and safety because of their low-profile design and ability to fit a range of patients without requiring custom joint alignment. However, no existing…
This paper presents a nonlinear control design for highly underactuated balance robots, which possess more numbers of unactuated degree-of-freedom (DOF) than actuated ones. To address the challenge of simultaneously trajectory tracking of…
Precise in-hand manipulation of force-sensitive objects typically requires judicious coordinated force planning as well as accurate contact force feedback and control. Unlike multi-arm platforms with gripper end effectors, multi-fingered…
This paper presents a physical interface for collaborative mobile manipulators in industrial manufacturing and logistics applications. The proposed work builds on our earlier MOCA-MAN interface, through which an operator could be physically…
Humans possess a remarkable ability to react to unpredictable perturbations through immediate mechanical responses, which harness the visco-elastic properties of muscles to maintain balance. Inspired by this behaviour, we propose a novel…
State-of-the-art motorized hand prostheses are endowed with actuators able to provide independent and proportional control of as many as six degrees of freedom (DOFs). The control signals are derived from residual electromyographic (EMG)…
This paper presents a novel actuator system combining a twisted string actuator (TSA) with a winch mechanism. Relative to traditional hydraulic and pneumatic systems in robotics, TSAs are compact and lightweight but face limitations in…
In this work, we introduce the EyeSight Hand, a novel 7 degrees of freedom (DoF) humanoid hand featuring integrated vision-based tactile sensors tailored for enhanced whole-hand manipulation. Additionally, we introduce an actuation scheme…
In this article, we will construct an overconstrained closed-loop linkage consisting of four revolute and one cylindrical joint. It is obtained by factorization of a prescribed vertical Darboux motion. We will investigate the kinematic…
Inspired by the dexterous handling ability of an elephant's trunk, we propose a pneumatic actuator that generates diverse bending and extension motions in a flexible arm. The actuator consists of two flexible tubes. Each flexible tube is…
Assistive robots offer agency to humans with severe motor impairments. Often, these users control high-DoF robots through low-dimensional interfaces, such as using a 1-D sip-and-puff interface to operate a 6-DoF robotic arm. This mismatch…
Soft grippers are receiving growing attention due to their compliance-based interactive safety and dexterity. Hybrid gripper (soft actuators enhanced by rigid constraints) is a new trend in soft gripper design. With right structural…
This paper present a novel dual-speed actuator adapted to robotics. In many applications, robots have to bear large loads while moving slowly and also have to move quickly through the air with almost no load. This lead to conflicting…
This paper introduces a novel design for a robotic hand based on parallel mechanisms. The proposed hand uses a triple-symmetric Bricard linkage as its reconfigurable palm, enhancing adaptability to objects of varying shapes and sizes.…
Dexterous hands enable concurrent prehensile and nonprehensile manipulation, such as holding one object while interacting with another, a capability essential for everyday tasks yet underexplored in robotics. Learning such long-horizon,…
This paper presents a sim-to-real approach that enables legged robots to dynamically manipulate large and heavy objects with whole-body dexterity. Our key insight is that by performing test-time steering of a pre-trained whole-body control…
While its biological significance is well-documented, its application in soft robotics, particularly for the transport of fragile and irregularly shaped objects, remains underexplored. This study presents a modular soft robotic actuator…
This paper investigates the combined benefits of full-duplex (FD) and cell-free massive multiple-input multipleoutput (CF-mMIMO), where a large number of distributed access points (APs) having FD capability simultaneously serve numerous…
A robotic hand design suitable for dexterity should be examined using functional tests. To achieve this, we designed a mechanical glove, which is a rigid wearable glove that enables us to develop the corresponding isomorphic robotic hand…