Related papers: Deposition Rates in Thermal Laser Epitaxy: Simulat…
Atom probe tomography data is composed of a list of coordinates of the reconstructed atoms in the probed volume. The elemental identity of each atom is derived from time-of-flight mass spectrometry, with no local energetic or chemical…
Heating and ionization are among the most fundamental processes in relativistic laser--solid interactions; however, their spatiotemporal evolution remains challenging to capture experimentally. Here we present detailed diagnosis of…
X-ray Thomson scattering (XRTS) is a common diagnostic used in the warm dense matter (WDM) regime to estimate plasma parameters like density, temperature and charge state. Experimental analysis typically relies on a forward model to obtain…
We study laser cooling of atomic gases by collisional redistribution of fluorescence. In a high pressure buffer gas regime, frequent collisions perturb the energy levels of alkali atoms, which allows for the absorption of a far red detuned…
In recent years, there are increasing evidence for a thermal emission component that accompanies the overall non-thermal spectra of the prompt emission phase in GRBs. Both the temperature and flux of the thermal emission show a well defined…
Recently, there has been a growing interest in the usage of mm-scale composites of plasmonic nanoparticles for enhancing the rates of chemical reactions; the effect was shown recently to be predominantly associated with the elevated…
We propose a thermodynamically consistent general-purpose model describing diffusion of a solute or a fluid in a solid undergoing possible phase transformations and damage, beside possible visco-inelastic processes. Also heat…
Emerging quality requirements in modern optical systems increase the need for accurate simulation and compensation of disturbances. One key disturbance in high-power laser applications results from thermal loading due to absorption. This…
In astrophysical conditions prevalent during the late times of stellar evolution, lepton ($e^-$ and $e^+$) emission processes compete with the corresponding lepton capture processes. Prior to the collapse, lepton emissions significantly…
It was shown by several authors that closed high pressure arc a.c. discharge in mercury vapors with addition of metal halide cannot be described in frames of the local thermodynamic equilibrium (LTE) model. However some plasma parameters…
At the ultra-thin limit below 20 nm, a film's electrical conductivity, thermal conductivity, or thermoelectricity depends heavily on its thickness. In most studies, each sample is fabricated one at a time, potentially leading to…
One of the defining characteristics of a solar flare is the impulsive formation of very high temperature plasma. The properties of the thermal emission are not well understood, however, and the analysis of solar flare observations is often…
The interaction of light with a material's electronic system creates an out-of-equilibrium (non-thermal) distribution of optically excited electrons. Non-equilibrium dynamics relaxes this distribution on an ultrafast timescale to a hot…
The statistical-thermodynamic dislocation theory developed in previous papers is used here in an analysis of high-temperature deformation of aluminum and steel. Using physics-based parameters that we expect theoretically to be independent…
Time-domain thermoreflectance (TDTR) is a well-established pump/probe method for measuring thermal conductivity and interface conductance of multilayers. Interpreting signals in a TDTR experiment requires a thermal model.In standard…
Laser ablation in liquid (LAL) is important technique used for formation of nanoparticles (NP). The LAL processes cover logarithmically wide range of spatiotemporal scales and is not fully understood. The NP produced by LAL are rather…
Laser melting of semiconductors has been observed for almost 40 years; surprisingly, it is not well understood where most theoretical simulations show a laser-induced thermal process. $\textit{Ab initio}$ nonadiabatic simulations based on…
Accurate evaluation of enthalpy of vaporization (or latent heat of vaporization) and its variation with temperature is of great interest in practical applications, especially for combustion of liquid fuels. Currently, a theoretically…
The development of thermal stresses inside refractory ceramics experiencing severe thermal shock is studied. The present analysis departs from the linear theory of thermal stresses as it accounts for temperature dependent thermal and…
We numerically and experimentally investigate evaporation of a sessile droplet on a heated substrate. We develop a finite element (FE) model in two-dimensional axisymmetric coordinates to solve coupled transport of heat in the droplet and…