Related papers: Modulo Sampling: Performance Guarantees in The Pre…
This study addresses a key limitation in deep learning Automatic Modulation Classification (AMC) models, which perform well at high signal-to-noise ratios (SNRs) but degrade under noisy conditions due to conventional feature extraction…
Obtaining digital representations of multivariate continuous-time (CT) signals is a challenge encountered in many signal processing systems. In practice, these signals are often acquired to extract some underlying information, i.e., for a…
Having lower quantization resolution, has been introduced in the literature, as a solution to reduce the power consumption of massive MIMO and millimeter wave MIMO systems. In this paper, we analyze bit error rate (BER) performance of…
With the recent burst of 2D and 3D data, cross-modal retrieval has attracted increasing attention recently. However, manual labeling by non-experts will inevitably introduce corrupted annotations given ambiguous 2D/3D content. Though…
Coping with noise in quantum computation poses significant challenges due to its unpredictable nature and the complexities of accurate modeling. This paper presents noise-adaptive folding, a technique that enhances zero-noise extrapolation…
The use of 1-bit analog-to-digital converters (ADCs) is seen as a promising approach to significantly reduce the power consumption and hardware cost of multiple-input multiple-output (MIMO) receivers. However, the nonlinear distortion due…
The Unlimited Sensing Framework (USF) was recently introduced to overcome the sensor saturation bottleneck in conventional digital acquisition systems. At its core, the USF allows for high-dynamic-range (HDR) signal reconstruction by…
Leveraging the available millimeter wave spectrum will be important for 5G. In this work, we investigate the performance of digital beamforming with low resolution ADCs based on link level simulations including channel estimation, MIMO…
Quantizers play a critical role in digital signal processing systems. Recent works have shown that the performance of quantization systems acquiring multiple analog signals using scalar analog-to-digital converters (ADCs) can be…
Previous work regarding low-rank matrix recovery has concentrated on the scenarios in which the matrix is noise-free and the measurements are corrupted by noise. However, in practical application, the matrix itself is usually perturbed by…
Optimizing multimodal waveguide performance depends on modal analysis; however, existing methods focus predominantly on modal power distribution (MPD) and, limited by experimental hardware and conditions, exhibit low accuracy, poor…
Motivated by the practical constraints arising in emerging sensor network and Internet-of-Things (IoT) applications, the zero-delay transmission of a Gaussian measurement over a real single-input multiple-output (SIMO) additive white…
In this letter, we derive an approximate analytical expression for the uplink achievable rate of a massive multi-input multi-output (MIMO) antenna system when finite precision analog-digital converters (ADCs) and the common maximal ratio…
In this contribution, it is proposes to limit the quantization search space of a successive approximation analog-to-digital converter through an analytic derivation of maximum possible sample-to-sample variation. The presented example…
This article proposes a method for the measurement of Phase Noise (PN, or PM noise) and Amplitude Noise (AN, or AM noise) of Digital-to-Analog Converters (DAC) and Direct Digital Synthesizers (DDS) based on modulation-index amplification.…
An alternative to conventional uniform sampling is that of time encoding, which converts continuous-time signals into streams of trigger times. This gives rise to Event-Driven Sampling (EDS) models. The data-driven nature of EDS acquisition…
This work studies a multi-cell one-bit massive multiple-input multiple-output (MIMO) system that employs one-bit analog-to-digital converters (ADCs) and digital-to-analog converters (DACs) at each base station (BS). We utilize Bussgang…
We investigate massive multiple-input-multiple output (MIMO) uplink systems with 1-bit analog-to-digital converters (ADCs) on each receiver antenna. Receivers that rely on 1-bit ADC do not need energy-consuming interfaces such as automatic…
This paper considers a multipair amplify-and-forward massive MIMO relaying system with one-bit ADCs and one-bit DACs at the relay. The channel state information is estimated via pilot training, and then utilized by the relay to perform…
In this study, we statistically analyze the performance of a threshold-based multiple optical signal selection scheme (TMOS) for wavelength division multiplexing (WDM) and adaptive coded modulation (ACM) using free space optical (FSO)…