Related papers: Modulo Sampling: Performance Guarantees in The Pre…
In the uplink of a cell-free massive MIMO system, quantization affects performance in two key domains: the time-domain distortion introduced by finite-resolution analog-to-digital converters (ADCs) at the access points (APs), and the…
Modulo sampling and dithered one-bit quantization frameworks have emerged as promising solutions to overcome the limitations of traditional analog-to-digital converters (ADCs) and sensors. Modulo sampling, with its high-resolution approach…
We consider general multi-antenna fading channels with coarsely quantized outputs, where the channel is unknown to the transmitter and receiver. This analysis is of interest in the context of sensor network communication where low power and…
The power consumption of high-speed, high-resolution analog to digital converters (ADCs) is a limiting factor in implementing large-bandwidth mm-wave communication systems. A mitigating solution, which has drawn considerable recent…
Energy-efficient signal processing systems require estimation methods operating on data collected with low-complexity devices. Using analog-to-digital converters (ADC) with $1$-bit amplitude resolution has been identified as a possible…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…
Following the Unlimited Sampling strategy to alleviate the omnipresent dynamic range barrier, we study the problem of recovering a bandlimited signal from point-wise modulo samples, aiming to connect theoretical guarantees with hardware…
In this paper we prove optimality of a certain class of Analog to Digital Converters (ADCs), which can be viewed as generalized Delta-Sigma Modulators (DSMs), with respect to a performance measure that can be characterized as the worst-case…
In this work, we consider the acquisition of stationary signals using uniform analog-to-digital converters (ADCs), i.e., employing uniform sampling and scalar uniform quantization. We jointly optimize the pre-sampling and reconstruction…
Sampling and quantization are crucial in digital signal processing, but quantization introduces errors, particularly due to distribution mismatch between input signals and quantizers. Existing methods to reduce this error require precise…
Conventional digitization based on the Shannon-Nyquist method, implemented via analog-to-digital converters (ADCs), faces fundamental limitations. High-dynamic-range (HDR) signals often get clipped or saturated in practice. Given a fixed…
Modulo sampling (MS) has been recently introduced to enhance the dynamic range of conventional ADCs by applying a modulo operator before sampling. This paper examines the identifiability of a measurement model where measurements are taken…
In this work, we investigate dynamic oversampling techniques for large-scale multiple-antenna systems equipped with low-cost and low-power 1-bit analog-to-digital converters at the base stations. To compensate for the performance loss…
Analog to Digital Converters (ADCs) are a major contributor to the energy consumption on the receiver side of millimeter-wave multiple-input multiple-output (MIMO) systems with large antenna arrays. Consequently, there has been significant…
We investigate full-duplex (FD) multi-user multiple input single-output systems with coarse quantization, aiming to characterize the impact of employing low-resolution analog-to-digital converters (ADCs) on self-interference (SI) and to…
This paper focuses on channel estimation in single-user and multi-user MIMO systems with multi-antenna base stations equipped with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). A careful selection of the quantization…
We study the problem of approximately recovering signals on a manifold from one-bit linear measurements drawn from either a Gaussian ensemble, partial circulant ensemble, or bounded orthonormal ensemble and quantized using Sigma-Delta or…
Cell-free massive MIMO has matured into a key candidate technology for 6G and beyond, owing to its ability to provide nearly uniform service quality to many user equipments (UEs) over the same time-frequency resources. Unlike conventional…
This paper focuses on channel estimation for mmWave MIMO systems with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). The channel estimation performance with 1-bit spatial sigma-delta ADCs depends on the quantization noise…