Related papers: Joint Phase Time Array: Opportunities, Challenges …
Channel estimation is essential for precoding/combining in millimeter wave (mmWave) communications. However, accurate estimation is usually difficult because the receiver can only observe the low-dimensional projection of the received…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
Joint radar-communications (JRC) benefits from multi-functionality of radar and communication operations using same hardware and radio frequency (RF) spectrum resources. Thus JRC systems possess very high potential to be employed into the…
To achieve high-speed (giga-bit) connectivity for short-range wireless multimedia applications, the millimeter-wave (mmWave) wireless personal area networks with directional antennas are gaining increased interest. Due to the use of…
Josephson traveling-wave parametric amplifiers (JTWPAs) are wideband, ultralow-noise amplifiers used to enable the readout of superconducting qubits. While individual JTWPAs have achieved high performance, behavior between devices is…
Demonstrating the feasibility of large antenna array beamforming is essential for realizing mmWave communication systems. This is due to the dependency of these systems on the large array beamforming gains to provide sufficient received…
Frequency Phase Transfer (FPT) is a technique designed to increase coherence and sensitivity in radio interferometry by making use of the non-dispersive nature of the troposphere to calibrate high-frequency data using solutions derived at a…
Millimeter wave (mmWave) communications systems are promising candidate to support extremely high data rate services in future wireless networks. MmWave communications exhibit high penetration loss (blockage) and require directional…
Milimeter wave (mmWave) band mobile communications can be a solution to the continuously increasing traffic demand in modern wireless systems. Even though mmWave bands are scarcely occupied, the design of a prospect transceiver should…
Hybrid analog/digital precoding offers a compromise between hardware complexity and system performance in millimeter wave (mmWave) systems. This type of precoding allows mmWave systems to leverage large antenna array gains that are…
Distributed phased arrays based multiple-input multiple-output (DPA-MIMO) is a newly introduced architecture that enables both spatial multiplexing and beamforming while facilitating highly reconfigurable hardware implementation in…
The use of millimeter wave (mmWave) frequencies for communication will be one of the innovations of the next generation of cellular mobile networks (5G). It will provide unprecedented data rates, but is highly susceptible to rapid channel…
Wireless power transfer (WPT) has garnered increasing attention due to its potential to eliminate device-side batteries. With the advent of (distributed) multiple-input multiple-output (MIMO), radio frequency (RF) WPT has become feasible…
Polarimetric phased arrays (PPAs) enhance radar target detection and anti-jamming capabilities, but their conventional dual transmit/receive (T/R) channel architecture leads to high cost and system complexity. To address these limitations,…
Multibeam technology enables the use of two or more subbeams for joint communication and radio sensing, to meet different requirements of beamwidth and pointing directions. Generating and optimizing multibeam subject to the requirements is…
Resonant beam charging (RBC) can realize wireless power transfer (WPT) from a transmitter to multiple receivers via resonant beams. The adaptive RBC (ARBC) can effectively improve its energy utilization. In order to support multi-user WPT…
Multicast beamforming is known to improve spectral efficiency. However, its benefits and challenges for hybrid precoders design in millimeter-wave (mmWave) systems remain understudied. To this end, this paper investigates the first joint…
Millimeter-wave (mmWave) communication is a promising technology to cope with the exponential increase in 5G data traffic. Such networks typically require a very dense deployment of base stations. A subset of those, so-called macro base…
The recent concept of beamspace multiple input multiple output (MIMO) can significantly reduce the number of required radio-frequency (RF) chains in millimeter-wave (mmWave) massive MIMO systems without obvious performance loss. However,…
This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility…