Related papers: Stability of Crossed-Field Amplifiers
Dispersive readouts for superconducting qubits have the advantage of speed and minimal invasiveness. We have developed such an amplifier, the Cavity Bifurcation Amplifier (CBA) [10], and applied it to the readout of the quantronium qubit…
Scaling of multi-pixel cryogenic detectors for imaging becomes increasingly difficult with size due to complexity of readout circuitry and cryogenic constraints (thermal load from wiring). We propose and demonstrate a new readout scheme…
The reconfigurable coupler antenna (RCA), also called the flexible coupler antenna (FCA), is a new technique that aims to improve the performance of wireless communication networks by reconfiguring the positions and rotations of low-cost…
We present a comprehensive study of laser pulse amplification with respect to operation regimes, gain dynamics, and highly stable operation points of Ho:YLF regenerative amplifiers (RAs). The findings are expected to be more generic than…
This paper reviews the main types of r.f. power amplifiers which are, or may be, used for particle accelerators. It covers solid-state devices, tetrodes, inductive output tubes, klystrons, magnetrons, and gyrotrons with power outputs…
We address two aspects of the dynamics of the forced Duffing oscillator which are relevant to the technology of micromechanical devices and, at the same time, have intrinsic significance to the field of nonlinear oscillating systems. First,…
In a duct-flute such as the recorder, steady-state oscillations are controlled by two parameters, the blowing pressure and the frequency of the acoustic resonator. As in most feedback oscillators, the oscillation amplitude is determined by…
Two different oscillation modes in microdischarge with parallel-plate geometry has been observed: relaxation oscillations with frequency range between 1.23 and 2.1 kHz and free-running oscillations with 7 kHz frequency. The oscillation…
In this paper we describe an instability, which we called a Plasma-Cascade Amplifier, occurring in electron beams propagating along a straight trajectory.
Precision instrumentation systems, such as optical receivers and other current-output measurement systems, often contain a transimpedance amplifier (TIA). The commonly used resistive feedback TIA (RF-TIA) has a drawback in its practical…
This paper is a theoretical and a numerical investigation of the stability of a tip-cantilever system used in noncontact atomic force microscopy (NC-AFM) when it oscillates close to a surface. No additional dissipative force is considered.…
This study investigates the existence and stability of limit cycles resulting from self-excited oscillations in linear multi-degree-of-freedom systems subjected to discontinuous, state-dependent forcing. Using the method of averaging and…
We present a simple nonlinear resonant analog circuit which demonstrates quantization of resonating amplitudes, for a given excitation level. The system is a simple RLC resonator where C is an active capacitor whose value is related to the…
We report on the design and characterization of a high-power amplifier with an output power of 36.5 dBm for a frequency range of 50 MHz to 1000 MHz with a total gain of 40 dB. The amplifier is optimized for driving acousto-optic and…
Solid state amplifiers are being increasingly used instead of electronic vacuum tubes to feed accelerating cavities with radio frequency power in the 100 kW range. Power is obtained from the combination of hundreds of transistor amplifier…
The Self-Excited Loop (SEL) architecture, used in some continuous-wave (CW) superconducting linacs, relies on a positive feedback mechanism that requires carefully defined operating limits to ensure stable operation. These limits are…
We present a detailed description of the methods used in our model of mode instability in high-power, rare earth-doped, large-mode-area fiber amplifiers. Our model assumes steady-periodic behavior, so it is appropriate to operation after…
We investigate energy transfer and localization in a linear time-invariant oscillator chain weakly coupled to a forced nonlinear actuator. Two types of perturbation are studied: (1) harmonic forcing with a constant frequency is applied to…
This paper is a theoretical and a numerical investigation of the stability of a tip-cantilever system used in Non-Contact Atomic Force Microscopy (NC-AFM) when it oscillates close to a surface. No additional dissipative force is considered.…
We study the fluctuation-activated transition process in a system of two coupled bistable oscillators, in which each oscillator is driven by one constant force and an independent Gaussian white noise. The transition pathway has been…