Related papers: System-Level Analysis for mm-Wave Full-Duplex Tran…
In-band full duplex wireless is of utmost interest to future wireless communication and networking due to great potentials of spectrum efficiency. IBFD wireless, however, is throttled by its key challenge, namely self-interference.…
Much stringent reliability and processing latency requirements in ultra-reliable-low-latency-communication (URLLC) traffic make the design of linear massive multiple-input-multiple-output (M-MIMO) receivers becomes very challenging.…
This paper proposes an interleaved transceiver design method for a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system utilizing orthogonal frequency division multiplexing (OFDM) waveforms. We consider a…
Full-duplex (FD) wireless can significantly enhance spectrum efficiency but requires effective self-interference (SI) cancellers. RF SI cancellation (SIC) via frequency-domain equalization (FDE), where bandpass filters channelize the SI, is…
In the context of integrated sensing and communication (ISAC), a full-duplex (FD) transceiver can operate as a monostatic radar while maintaining communication capabilities. This paper investigates the design of precoders and combiners for…
Despite the intensive recent research on wireless single-channel full-duplex communications, relatively little is known about the transceiver chain nonidealities of full-duplex devices. In this paper, the effect of nonlinear distortion…
Machine learning (ML) can be used in various ways to improve multi-user multiple-input multiple-output (MU-MIMO) receive processing. Typical approaches either augment a single processing step, such as symbol detection, or replace multiple…
In this paper we present the realization and a preliminary characterization of a SIS based receiver. It has been developed for the MASTER experiment that consists in a three-band SIS receiver (94, 225 and 345 GHz) for astrophysical…
Next-generation communication systems with wide bandwidths need to operate in interference-limited networks. A discrete-time delay (TD) technique in a baseband receiver array is proposed for canceling wide modulated bandwidth spatial…
The acquisition of channel state information (CSI) is essential in MIMO-OFDM communication systems. Data-aided enhanced receivers, by incorporating domain knowledge, effectively mitigate performance degradation caused by imperfect CSI,…
Recent experimental results have shown that full-duplex communication is possible for short-range communications. However, extending full-duplex to long-range communication remains a challenge, primarily due to residual self-interference…
When considering the effect of quantum noise (QN) in a phase-insensitive linear amplifier or attenuator, it is customary to use the single channel Caves model (SC-CM). Although this model is valid in simple situations, such as the presence…
We consider a multi-user multiple-input multiple-output (MIMO) setup where full-duplex (FD) multi-antenna nodes apply linear beamformers to simultaneously transmit and receive multiple streams over Rician fading channels. The exact first…
This paper investigates one possible solution to the problem of self-interference cancellation (SIC) arising in the design of in-band full-duplex (IBFD) communication systems. Self-interference cancellation is performed in the digital…
Characterizing self-interference is essential to the design and evaluation of in-band full-duplex communication systems. Until now, little has been understood about this coupling in full-duplex systems operating at millimeter wave (mmWave)…
Co-channel interference cancellation (CCI) is the process used to reduce interference from other signals using the same frequency channel, thereby enhancing the performance of wireless communication systems. An improvement to this approach…
Integrated sensing and communication (ISAC) has been considered a key feature of next-generation wireless networks. This paper investigates the joint design of the radar receive filter and dual-functional transmit waveform for the…
A hybrid transmit precoder (TPC) and receive combiner (RC) pair is conceived for millimeter wave (mmWave) multiple input multiple output (MIMO) integrated sensing and communication (ISAC) systems. The proposed design considers a practical…
In this letter, we study the problem of cooperative sensing design for an orthogonal frequency division multiplexing (OFDM) multiple base stations (MBS) system. We consider a practical scenario where the base stations (BSs) exploit certain…
Multistatic integrated sensing and communications (ISAC) systems, which use distributed transmitters and receivers, offer enhanced spatial coverage and sensing accuracy compared to stand-alone ISAC configurations. However, these systems…