Related papers: Rubber wear: experiment and theory
We present an experimental and theoretical study of dry and glycerol-lubricated sliding for polymethyl methacrylate (PMMA) cylinders with different surface roughness sliding on polydimethylsiloxane (PDMS) rubber. This system represents a…
Molecular dynamics simulations are used to investigate the influence of molecular-scale surface roughness on the slip behavior in thin liquid films. The slip length increases almost linearly with the shear rate for atomically smooth rigid…
This paper reports on the frictional properties of smooth rubber substrates sliding against rigid surfaces covered with various densities of colloidal nano-particles (average diameter 77 nm). Friction experiments were carried out using a…
We study the time dependency of the (average) interfacial separation between an elastic solid with a flat surface and a rigid solid with a randomly rough surface, squeezed together in a fluid. We use an analytical theory describing the…
We develop an analytical model of adhesive wear between two unlubricated rough surfaces, forming micro-contacts under normal load. The model is based on an energy balance and a crack initiation criteria. We apply the model to the problem of…
We report on experimental measurements of the flow behavior of a wet, two-dimensional foam under conditions of slow, steady shear. The initial response of the foam is elastic. Above the yield strain, the foam begins to flow. The flow…
Liquid wetting of a surface is omnipresent in nature and the advance of micro-fabrication and assembly techniques in recent years offers increasing ability to control this phenomenon. Here, we identify how surface roughness influences the…
We present an experimental investigation of the non stationary frictional properties of multicontact interfaces between rough elastomers and rough hard glass at low velocities (<= 200 mu m s^{-1}). These systems, for which the deformation…
We study tribological granite-granite contacts as a model for tectonic faulting, combining experiments, theory, and molecular dynamics simulations. The high friction in this system is not dominated by particulate wear or plowing, as…
Surface roughness is a key factor when it comes to friction and wear, as well as to other physical properties. These phenomena are controlled by mechanisms acting at small scales, in which the topography of apparently-flat surfaces is…
Contacts between particles in dense, sheared suspensions are believed to underpin much of their rheology. Roughness and adhesion are known to constrain the relative motion of particles, and thus globally affect the shear response, but an…
The shear wave speed is an upper limit for the speed of cracks loaded in tension in linear elastic solids. We have discovered that in a non-linear material, cracks in tension (Mode I) exceed this sound speed, and travel in an intersonic…
The increasing development of the solar energy industry in many countries has led to a rising frequency of human and robot presence in this area. To ensure occupational safety, various protective equipment, including rubber material, is…
It is commonly assumed that fluid cannot slip along a solid surface. The experimental evidence generally supports this assumption. We demonstrate that when the change of the relative velocity of a fluid and a solid wall is sufficiently…
In this article, we study the spreading of droplets of density-matched granular suspensions on the surface of a solid. Bidispersity of the particle size distribution enriches the conclusions drawn from monodisperse experiments by…
The drying rate profile of granular beds can be divided into the constant rate period (CRP), which is characterized by a nearly constant drying rate, and the falling rate period (FRP), in which the drying rate rapidly decays. In order to…
We numerically investigate the effects of fiber aspect ratio, roughness, flexibility, and flow inertia on the rheology of concentrated suspensions. We perform direct numerical simulations modeling the fibers, suspended in an incompressible…
In this paper, we report on new experimental results on the effects of in-plane surface stretching on the friction of Poly(DiMethylSiloxane) (PDMS) rubber with smooth rigid probes. Friction-induced displacement fields are measured at the…
We present exact numerical results for the friction force and the contact area for a viscoelastic solid (rubber) in sliding contact with hard, randomly rough substrates. The rough surfaces are self-affine fractal with roughness over several…
When two solids are squeezed together they will in general not make atomic contact everywhere within the nominal (or apparent) contact area. This fact has huge practical implications and must be considered in many technological…