Related papers: Location and Map-Assisted Wideband Phase and Time …
We consider channel estimation for high-speed railway communication systems, where both the transmitter and the receiver are equipped with large-scale antenna arrays. It is known that the throughput of conventional training schemes…
To reap the promised gain achieved by distributed reconfigurable intelligent surfaces (RISs)-enhanced communications in a wireless network, timing synchronization among these metasurfaces is an essential prerequisite in practice. This paper…
Accurate channel model and channel estimation are essential to empower extremely large-scale MIMO (XL-MIMO) in 6G networks with ultra-high spectral efficiency. With the sharp increase in the antenna array aperture of the XL-MIMO scenario,…
This paper proposes a novel phase identification method for distribution networks where phases can be severely unbalanced and insufficiently labeled. The analysis approach draws on data from high-precision phasor measurement units…
Over the years, advancements such as increased bandwidth, new modulation and coding schemes, frame aggregation, and the use of multiple antennas have been employed to enhance Wi-Fi performance. Nonetheless, as network density and the demand…
The effective utilization of unlicensed spectrum is regarded as an important direction to enable the massive access and broad coverage for next-generation wireless local area network (WLAN). Due to the crowded spectrum occupancy and dense…
Millimeter wave (mmWave) technology is expected to be a major component of 5G wireless networks. Ultra-wide bandwidths of mmWave signals and the possibility of utilizing large number of antennas at the transmitter and the receiver allow…
Radio maps are essential for enhancing wireless communications and localization. However, existing methods for constructing radio maps typically require costly calibration processes to collect location-labeled channel state information…
Motivated by future automotive applications, we study some joint radar target detection and parameter estimation problems where the transmitter, equipped with a mono-static MIMO radar, wishes to detect multiple targets and then estimate…
Constrained environments, such as indoor and urban settings, present a significant challenge for accurate moving object positioning due to the diminished line-of-sight (LoS)communication with the wireless anchor used for positioning. The…
Mobile device localization in wireless sensor networks is a challenging task. It has already been addressed when the WiFI propagation maps of the access points are modeled deterministically. However, this procedure does not take into…
Distributed MIMO and integrated sensing and communication are expected to be key technologies in future wireless systems, enabling reliable, low-latency communication and accurate localization. Dedicated localization solutions must support…
Achieving coherent integration in distributed Internet of Things (IoT) sensing networks requires precise synchronization to jointly compensate clock offsets and radio-frequency (RF) phase errors. Conventional two-step protocols suffer from…
This paper presents a phase-difference-based scheme for three-dimensional (3D) line-of-sight (LoS) user localization using a uniform planar array (UPA), applicable to both near-field and far-field regimes under the exact spherical-wave…
A distributed MIMO radar is considered, in which the transmit and receive antennas belong to nodes of a small scale wireless network. The transmit waveforms could be uncorrelated, or correlated in order to achieve a desirable beampattern.…
Although routinely utilized in literature, orthogonal waveforms may lose orthogonality in distributed multi-input multi-output (MIMO) radar with spatially separated transmit (TX) and receive (RX) antennas, as the waveforms may experience…
Time-based indoor positioning techniques rely on multiple access points (APs) and measurements between the user equipment (UE) and the APs. In dense indoor environments, occlusion-induced non-line-of-sight (NLoS) propagation introduces…
This paper proposes a high-accuracy radio map construction method tailored for environments where location information is affected by bursty errors. Radio maps are an effective tool for visualizing wireless environments. Although extensive…
A simple feedback control algorithm is presented for distributed beamforming in a wireless network. A network of wireless sensors that seek to cooperatively transmit a common message signal to a Base Station (BS) is considered. In this…
We demonstrate a wireless, decentralized time-alignment method for distributed antenna arrays and distributed wireless networks that achieves picosecond-level synchronization. Distributed antenna arrays consist of spatially separated…