Related papers: Optimization and Characterization of Thermoelectri…
At the ultra-thin film limit, quantum confinement strongly improves thermoelectric figure of merit in materials such as Sb$_2$Te$_3$ and Bi$_2$Te$_3$. These high quality films have only been realized using well controlled techniques such as…
Tellurium (Te) is an intrinsically p-type doped narrow bandgap semiconductor with excellent electrical conductivity and low thermal conductivity. Bulk trigonal Te has been theoretically predicted and experimentally demonstrated to be an…
The growing market for sensors, internet of things, and wearable devices is fueling the development of low-cost energy-harvesting materials and systems. Film based thermoelectric (TE) devices offer the ability to address the energy…
The optimization of secondary phase in thermoelectric(TE) materials can {helps in improvisation of material's efficiency}. Being a potential {contender} for lower temperature TE application, bismuth telluride(Bi$_2$Te$_3$) nanoparticles…
Thermoelectric materials intrigue much interest due to their wide range of application such as power generators and refrigerators. The efficiency of thermoelectric materials is quantified by the figure of merit, and a figure greater than…
Bismuth telluride (Bi2Te3) and its alloys are the best bulk thermoelectric materials known today. The stacked quasi-two-dimensional (2D) layers of Bi2Te3 were also identified as topological insulators. In this paper we describe a method for…
Two-dimensional (2D) elemental semiconductors have great potential for device applications, but their performance is limited by the lack of efficient doping methods. Here, combining molecular beam epitaxy, scanning tunneling…
At the ultra-thin limit below 20 nm, a film's electrical conductivity, thermal conductivity, or thermoelectricity depends heavily on its thickness. In most studies, each sample is fabricated one at a time, potentially leading to…
We report on "graphene-like" mechanical exfoliation of single-crystal Bi2Te3 films and thermoelectric characterization of the stacks of such films. Thermal conductivity of the resulting "pseudo-superlattices" was measured by the "hot disk"…
We present the effects of lead doping on the thermoelectric properties of Tellurium Telluride, prepared by solid state reactions in an evacuated sealed silica tubes. Structurally, all these compounds were found to be phase pure as confirmed…
We report on graphene-like exfoliation of the large-area crystalline films and ribbons of bismuth telluride with the thicknesses of a few atoms. It is demonstrated that bismuth telluride, the most important material for thermoelectric…
Large-volume deployment of Si-based Seebeck generators can be foreseen only if polycrystalline rather than single crystalline materials can be actually used. The aim of this study was therefore to verify whether polycrystalline Si films…
In 2016, bulk tellurium was experimentally observed as a remarkable thermoelectric material. Recently, two-dimensional (2D) tellurium, called tellurene, has been synthesized and has exhibited unexpected electronic properties compared with…
Thermoelectric (TE) materials achieve localised conversion between thermal and electric energies, and the conversion efficiency is determined by a figure of merit zT. Up to date, two-dimensional electron gas (2DEG) related TE materials hold…
Thermoelectricity refers to the conversion of thermal energy into electrical energy and vice-versa, which relies on three main effects: Seebeck, Peltier and Thomson, all of which are manifestations of heat and electricity flow. In this work…
The conventional thermoelectric figure of merit and the power factor are not sufficient as a measure of thin film quality of thermoelectric materials, where the power conversion efficiency depends on the film dimensions. By considering the…
Thermoelectric (TE) devices have been attracting increasing attention because of their ability to convert heat directly to electricity. To date, improving the TE figure of merit remains the key challenge. The advent of the topological…
Thermoelectric (TE) technology enables direct heat-to-electricity conversion and is gaining attention as a clean, fuel-saving, and carbon-neutral solution for industrial, automotive, and marine applications. Despite nearly a century of…
Thermoelectric films and periodic structures have particularly intriguing electrical and thermal transport features due to their low dimensionality. As a result, they have piqued the attention of researchers from across the spectrum of…
We have measured thermoelectric properties of Ta2PdX6 (X=S, Se) around room temperature using single crystal samples. We find that the power factor of Ta2PdX6 is relatively high from middle-low to room temperatures, and notably Ta2PdSe6…