Related papers: Postprocessing of tilt-to-length noise with coeffi…
TianQin is a proposed space-based mission for gravitational wave detection, employing a constellation of three drag-free satellites in high Earth orbits to form a laser interferometric observatory. A critical technical challenge is…
Tilts of certain elements within a laser interferometer can undesirably couple into measurements as a form of noise, known as tilt-to-length (TTL) coupling. This TTL coupling is anticipated to be one of the primary noise sources in the…
Tilt-to-length (TTL) noise from angular jitter in LISA is projected to be the dominant noise source in the milli-Hertz band unless corrected in post-processing. The correction is only possible after removing the overwhelming laser phase…
We present first-order models for tilt-to-length (TTL) coupling in LISA, both for the individual interferometers as well as in the time-delay interferometry (TDI) Michelson observables. These models include the noise contributions from…
The coupling of the angular jitter of the spacecraft and their sub-assemblies with the optical bench and the telescope into the interferometric length readout will be a major noise source in the LISA mission. We refer to this noise as…
For the LISA mission, Tilt-To-Length (TTL) coupling is expected to be one of the dominant instrumental noise contributions after laser frequency noise is suppressed based, on assumptions on the size of the coupling and angular jitter…
Tilt-to-length (TTL) noise induced by angular jitter of spacecraft and test masses can affect the sensitivity of space-based gravitational-wave detectors such as LISA, Taiji, and TianQin. Such angular jitter can be measured using the…
The Laser Interferometer Space Antenna (LISA) will be the first space-based gravitational wave (GW) observatory. It will measure gravitational wave signals in the frequency regime from 0.1 mHz to 1 Hz. The success of these measurements will…
The Taiji mission for space-based gravitational wave (GW) detection employs laser interferometry to measure picometer-scale distance variations induced by GWs. The tilt-to-length (TTL) coupling noise in the inter-spacecraft interferometers,…
This paper is the second in a set of two investigating tilt-to-length (TTL) coupling. TTL describes the cross-coupling of angular or translational jitter into an interferometric phase signal and is an important noise source in precision…
Tilt-to-length (TTL) coupling in the Laser Interferometer Space Antenna (LISA) can generate spurious displacement noise that potentially affects the measurement of gravitational wave signals. In each test mass interferometer, the coupling…
Time-delay interferometry (TDI) is a data processing technique for LISA designed to suppress the otherwise overwhelming laser noise by several orders of magnitude. It is widely believed that TDI can only be applied once all phase or…
The Laser Interferometer Space Antenna (LISA) mission features a three-spacecraft long-arm constellation intended to detect gravitational wave sources in the low-frequency band up to 1 Hz via laser interferometry. The paper presents an…
Pointing-related displacement noises are crucial in space-based gravitational wave detectors, where point-ahead angle control of transmitted laser beams may contribute significantly. For TianQin that features a geocentric concept, the…
Tilt-to-length (TTL) noise, caused by angular jitter and misalignment, is a major noise source in the inter-satellite interferometer for gravitational wave detection. However, the required level of axis alignment of the optical components…
Tilt-to-length coupling is a technical term for the cross-coupling of angular or lateral jitter into an interferometric phase signal. It is an important noise source in precision interferometers and originates either from changes in the…
Time-delay interferometry (TDI) is a post-processing technique used to reduce laser noise in heterodyne interferometric measurements with unequal armlengths, a situation characteristic of space gravitational detectors such as Laser…
The arm length and the isolation in space enable LISA to probe for signals unattainable on ground, opening a window to the sub-Hz gravitational-wave universe. The coupling of unavoidable angular spacecraft jitter into the longitudinal…
Time delay interferometry (TDI) is a key technique employed in gravitational wave (GW) space missions to mitigate laser frequency noise by combining multiple laser links and establishing an equivalent equal arm interferometry. The null…
Space-based gravitational wave (GW) observatories, such as the future Laser Interferometer Space Antenna (LISA), employ synthetic Time Delay Interferometry (TDI) to cancel the otherwise overwhelming laser frequency noise. The phase readouts…