Related papers: Double-Side Delay Alignment Modulation for Multi-U…

This paper investigates radar-assisted user acquisition for downlink multi-user multiple-input multiple-output (MIMO) transmission using Orthogonal Frequency Division Multiplexing (OFDM) signals. Specifically, we formulate a concise…

In this paper, we propose a beamforming design for dual-functional radar-communication (DFRC) systems at the millimeter wave (mmWave) band, where hybrid beamforming and sub-arrayed MIMO radar techniques are jointly exploited. We assume that…

In the context of communication-centric integrated sensing and communication (ISAC), the orthogonal frequency division multiplexing (OFDM) waveform was proven to be optimal in minimizing ranging sidelobes when random signaling is used. A…

Beamforming in multiple-input multiple-output (MIMO) systems should take interference mitigation into account. However, for beamform design, accurate channel state information (CSI) is needed, which is often difficult to obtain due to…

Communication at millimeter wave (mmWave) bands is expected to become a key ingredient of next generation (5G) wireless networks. Effective mmWave communications require fast and reliable methods for beamforming at both the User Equipment…

This paper investigates the symmetric degrees of freedom (DoF) of MIMO cellular networks with G cells and K users per cell, having N antennas at each base station and M antennas at each user. In particular, we investigate achievability…

Communication systems at millimeter-wave (mmW) and sub-terahertz frequencies are of increasing interest for future high-data rate networks. One critical challenge faced by phased array systems at these high frequencies is the efficiency of…

Integrated sensing and communication (ISAC) in monostatic in-band full-duplex (IBFD) systems encounters significant challenges due to self-interference (SI) at the radar receiver during concurrent communication and radar operations. This…

Coarsely quantized MIMO signalling methods have gained popularity in the recent developments of massive MIMO as they open up opportunities for massive MIMO implementation using cheap and power-efficient radio-frequency front-ends. This…

This paper conceives a hybrid beamforming design (HBF) that maximizes the energy efficiency (EE) of an integrated sensing and communication (ISAC)-enabled millimeter wave (mmWave) multiple-input multiple-output (MIMO) system. In the system…

Since the spectrum below 6 GHz bands is insufficient to meet the high bandwidth requirements of 5G use cases, 5G networks expand their operation to mmWave bands. However, operation at these bands has to cope with a high penetration loss and…

Emerging technologies, such as holographic multiple-input multiple-output (HMIMO) and stacked intelligent metasurface (SIM), are driving the development of wireless communication systems. Specifically, the SIM is physically constructed by…

We study a full-duplex (FD) cell-free massive MIMO system where distributed access points (APs) operate in FD mode while user equipments (UEs) remain half-duplex. Although simultaneous uplink (UL) and downlink (DL) transmissions improve…

Directional modulation (DM) is a physical layer security technique based on antenna arrays and so far the polarisation information has not been considered in its designs. To increase the channel capacity, we consider exploiting the…

Reconfigurable distributed antenna and reflecting surface (RDARS) is a promising architecture for future sixth-generation (6G) wireless networks. In particular, the dynamic working mode configuration for the RDARS-aided system brings an…

Delay-and-Sum (DAS) beamformer is the most common beamforming algorithm in Photoacoustic imaging (PAI) due to its simple implementation and real time imaging. However, it provides poor resolution and high levels of sidelobe. A new algorithm…

Stacked intelligent metasurfaces (SIMs), which integrate multiple programmable metasurface layers, have recently emerged as a promising technology for advanced wave-domain signal processing. SIMs benefit from flexible spatial…

In this paper, we consider linear MIMO transceiver design for a cellular two-way amplify-and-forward relaying system consisting of a single multi-antenna base station, a single multi-antenna relay station, and multiple multi-antenna mobile…

We propose a hybrid architecture that integrates RF (i.e., sub-6 GHz) and millimeter wave (mmWave) technologies for 5G cellular systems. In particular, communications in the mmWave band faces significant challenges due to variable channels,…

Stacked intelligent metasurfaces (SIMs) represent a key enabler for next-generation wireless networks, offering beamforming gains while significantly reducing radio-frequency chain requirements. In conventional space-only SIM architectures,…