Related papers: Tilt-To-Length Coupling in LISA -- Uncertainty and…

For the LISA mission, Tilt-To-Length (TTL) coupling is expected to be one of the dominant instrumental noise contributions after laser frequency noise is suppressed based, on assumptions on the size of the coupling and angular jitter…

Tilt-to-length (TTL) noise from angular jitter in LISA is projected to be the dominant noise source in the milli-Hertz band unless corrected in post-processing. The correction is only possible after removing the overwhelming laser phase…

Tilts of certain elements within a laser interferometer can undesirably couple into measurements as a form of noise, known as tilt-to-length (TTL) coupling. This TTL coupling is anticipated to be one of the primary noise sources in the…

This paper describes a setup aimed at measuring the so-called Tilt-To-Length (TTL) coupling in the optical benches of the LISA mission. The TTL is the coupling of the angular jitter of any optical setup into the optical path length between…

The arm length and the isolation in space enable LISA to probe for signals unattainable on ground, opening a window to the sub-Hz gravitational-wave universe. The coupling of unavoidable angular spacecraft jitter into the longitudinal…

The Laser Interferometer Space Antenna (LISA) will be the first space-based gravitational wave (GW) observatory. It will measure gravitational wave signals in the frequency regime from 0.1 mHz to 1 Hz. The success of these measurements will…

We present first-order models for tilt-to-length (TTL) coupling in LISA, both for the individual interferometers as well as in the time-delay interferometry (TDI) Michelson observables. These models include the noise contributions from…

Tilt-to-length (TTL) coupling in the Laser Interferometer Space Antenna (LISA) can generate spurious displacement noise that potentially affects the measurement of gravitational wave signals. In each test mass interferometer, the coupling…

Objects sensed by laser interferometers are usually not stable in position or orientation. This angular instability can lead to a coupling of angular tilt to apparent longitudinal displacement -- tilt-to-length coupling (TTL). In LISA this…

We present a study of the tilt-to-length coupling noise during the LISA Pathfinder mission and how it depended on the system's alignment. Tilt-to-length coupling noise is the unwanted coupling of angular and lateral spacecraft or test mass…

Tilt-to-length coupling is a technical term for the cross-coupling of angular or lateral jitter into an interferometric phase signal. It is an important noise source in precision interferometers and originates either from changes in the…

Tilt-to-length (TTL) noise induced by angular jitter of spacecraft and test masses can affect the sensitivity of space-based gravitational-wave detectors such as LISA, Taiji, and TianQin. Such angular jitter can be measured using the…

TianQin is a proposed space-based mission for gravitational wave detection, employing a constellation of three drag-free satellites in high Earth orbits to form a laser interferometric observatory. A critical technical challenge is…

The Laser Interferometer Space Antenna (LISA) mission features a three-spacecraft long-arm constellation intended to detect gravitational wave sources in the low-frequency band up to 1 Hz via laser interferometry. The paper presents an…

The Taiji mission for space-based gravitational wave (GW) detection employs laser interferometry to measure picometer-scale distance variations induced by GWs. The tilt-to-length (TTL) coupling noise in the inter-spacecraft interferometers,…

Tilt-to-length coupling was the limiting noise source in LISA Pathfinder between 20 and 200 mHz before subtraction in post-processing. To prevent the adding of sensing noise to the data by the subtraction process, the success of this…

This paper is the second in a set of two investigating tilt-to-length (TTL) coupling. TTL describes the cross-coupling of angular or translational jitter into an interferometric phase signal and is an important noise source in precision…

Tilt-to-length (TTL) noise, caused by angular jitter and misalignment, is a major noise source in the inter-satellite interferometer for gravitational wave detection. However, the required level of axis alignment of the optical components…

Tilt-to-length (TTL) coupling is expected to be one of the major noise sources in the interferometric phase readouts in TianQin mission. Arising from the angular motion of spacecraft (SC) and the onboard movable optical subassemblies…

The tilt-to-length coupling during the LISA Pathfinder mission has been numerically and analytically modeled for particular timespans. In this work, we investigate the long-term stability of the coupling coefficients of this noise. We show…