Related papers: A Block Quantum Genetic Interference Mitigation Al…
Massive multiple-input-multiple-output (MIMO) transmission is a promising technology to improve the capacity and reliability of wireless systems. However, the number of antennas that can be equipped at a base station (BS) is limited by the…
Full-duplex systems are expected to achieve 100% rate improvement over half-duplex systems if the self-interference signal can be significantly mitigated. In this paper, we propose the first full-duplex system utilizing Multi-Reconfigurable…
The dynamic allocation of spectrum in 5G / 6G networks is critical to efficient resource utilization. However, applying traditional deep reinforcement learning (DRL) is often infeasible due to its immense sample complexity and the safety…
Millimeter wave (mmWave) communication is a key component of 5G and beyond. Harvesting the gains of the large bandwidth and low latency at mmWave systems, however, is challenged by the sensitivity of mmWave signals to blockages; a sudden…
This work investigates a multibeam system for joint sensing and communication (JSC) based on multiple-input multiple-output (MIMO) 5G new radio (NR) waveforms. In particular, we consider a base station (BS) acting as a monostatic sensor…
This study considers a novel full-duplex (FD) massive multiple-input multiple-output (mMIMO) system using hybrid beamforming (HBF) architecture, which allows for simultaneous uplink (UL) and downlink (DL) transmission over the same…
This work presents blind joint interference suppression and power allocation algorithms for DS-CDMA networks with multiple relays and decode and forward protocols. A scheme for joint allocation of power levels across the relays subject to…
Joint Communication and Sensing (JCAS) is envisioned for 6G cellular networks, where sensing the operation environment, especially in presence of humans, is as important as the high-speed wireless connectivity. Sensing, and subsequently…
We study physical layer multicasting in multicell networks where each base station, equipped with multiple antennas, transmits a common message using a single beamformer to multiple users in the same cell. We investigate two coordinated…
With the incoming 5G network, the ubiquitous Internet of Things (IoT) devices can benefit our daily life, such as smart cameras, drones, etc. With the introduction of the millimeter-wave band and the thriving number of IoT devices, it is…
In this paper, we consider the design of a multiple-input multiple-output (MIMO) transmitter which simultaneously functions as a MIMO radar and a base station for downlink multiuser communications. In addition to a power constraint, we…
The transmitted signals in the fifth generation (5G) wireless networks suffer from significant path loss due to the use of higher frequencies in Sub-6 GHz and millimeter-wave (mmWave) bands. Inter-user interference in an ultra-dense network…
This paper considers a reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) downlink communication system where hybrid analog-digital beamforming is employed at the base station (BS). We formulate a power minimization…
Movable antenna (MA) has emerged as a promising technology to flexibly reconfigure wireless channels by adjusting antenna placement. In this paper, we study a dual-functional radar-communication (DFRC) system enhanced with movable antennas.…
Delay alignment modulation (DAM) is a novel wideband communication technique, which exploits the high spatial resolution and multi-path sparsity of millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems to mitigate…
Large antenna arrays and beamforming techniques are key components for exploiting the spectrum-rich FR2 bands in next-generation mobile communication networks. Given the site-specific spatio-temporal variations of the mm-wave channel,…
Future wireless networks will utilize extremely large-scale antenna arrays (ELAAs) over high-frequency bands, which, however, produce near-field spherical wavefronts and spatial wideband effects. To exploit and mitigate these, this paper…
Both dual-functional radar-communication (DFRC) and massive multiple-input multiple-output (MIMO) have been recognized as enabling technologies for 6G wireless networks. This paper considers the advanced waveform design for…
The sixth-generation (6G) wireless networks will rely on ultra-dense multi-cell deployment to meet the high rate and connectivity demands. However, frequency reuse leads to severe inter-cell interference, particularly for cell-edge users,…
In this paper, we focus on the design of the transmit waveforms of a frequency diverse array (FDA) in order to improve the output signal-to-interference-plus-noise ratio (SINR) in the presence of signal-dependent mainlobe interference.…