Related papers: Onset and impact of plastic deformation in granula…
The high-pressure compaction of three dimensional granular packings is simulated using a bonded particle model (BPM) to capture linear elastic deformation. In the model, grains are represented by a collection of point particles connected by…
Theoretical models of compaction processes, such as for example intergranular pressure-solution (IPS), focus on deformation occurring at the contacts between spherical grains that constitute an aggregate. In order to investigate the…
The quasistatic behavior of a simple 2D model of a cohesive powder under isotropic loads is investigated by Discrete Element simulations. The loose packing states, as studied in a previous paper, undergo important structural changes under…
A micromechanical approach is set-up to analyse the increase in elastic stiffness related to development of plastic deformation (the elastoplastic coupling concept) occurring during the compaction of a ceramic powder. Numerical simulations…
An extensive numerical campaign of particle mechanics calculations that predict microstructure formation and evolution during die compaction, up to relative densities close to one, of monodisperse plastic spheres that exhibit power-law…
Creep mechanisms in uniaxially compressed 3D granular solids comprised of faceted frictionless grains are studied numerically using a constant pressure and constant stress simulation method. Rapid uniaxial compression followed by slow…
The effect of a local shear transformation on plastic deformation of a three-dimensional amorphous solid is studied using molecular dynamics simulations. We consider a spherical inclusion, which is gradually transformed into an ellipsoid of…
We report on experiments to measure the temporal and spatial evolution of packing arrangements of anisotropic and weakly confined granular material, using high-resolution $\gamma$-ray adsorption. In these experiments, the particle…
Cold compaction of ceramic powders is driven by plastic strain, during which the elastic stiffness of the material progressively increases from values typical of granular matter to those representative of a fully dense solid. This increase…
We performed a series of numerical vertical compression tests on assemblies of 2D granular material using a Discrete Element code and studied the results with regard to the grain shape. The samples consist of 5,000 grains made from either 3…
Microstructural evolution in structural materials is known to occur in response to mechanical loading and can often accommodate substantial plastic deformation through the coupled motion of grain boundaries (GBs). This can produce desirable…
It is shown here that fracture after a brief plastic strain, typically of a few percents, is a necessary consequence of the polycrystalline nature of the materials. The polycrystal undergoing plastic deformation is modeled as a flowing…
The plastic flow of a polycrystal is analyzed assuming grains as fine that the rate limiting process is grain boundary sliding, and grains readily accommodate their shapes by slip to preserve spatial continuity. It is shown that thinking of…
The consolidation of suspended particulate matter under external forces such as pressure or gravity is of widespread interest. In this work, we derive a constitutive relation to describe the deformation of a {\it two-dimensional} strongly…
We show that the plastic deformation of snow under uniaxial compression is characterized by complex spatio-temporal strain localization phenomena. Deformation is characterized by repeated nucleation and propagation of compaction bands.…
In this work, a higher-order irrotational strain gradient plasticity theory is studied in the small strain regime. A detailed numerical study is based on the problem of simple shear of a non-homogeneous block comprising an elastic-plastic…
We present an experimental study of the compaction dynamics for two-dimensional anisotropic granular systems. Compaction dynamics is measured at three different scales : (i) the macroscopic scale through the packing fraction $\rho$, (ii)…
We study the impact of a projectile onto a bed of 3 mm grains immersed in an index-matched fluid. Specifically, we vary the amount of prestrain on the sample, strengthening the force chains within the system. We find this affects only the…
When stressed sufficiently, solid materials yield and deform plastically via reorganization of microscopic constituents. Indeed, it is possible to alter the micro-structure of materials by judicious application of stress, an empirical pro-…
Very soft grain assemblies have unique shape-changing capabilities that allow them to be compressed far beyond the rigid jammed state by filling void spaces more effectively. However, accurately following the formation of these systems by…