Related papers: The CuboDAQ Data Acquisition System
A front-end readout electronics system has been developed for silicon strip detectors. The system uses an application specific integrated circuit (ASIC) ATHED to realize multi-channel E&T measurement. The slow control of ASIC chips is…
Caribou is a flexible open-source DAQ system developed and used within several collaborative frameworks (CERN EP R&D, RD50, AIDAinnova) for laboratory and high-rate beam tests and easy integration of new silicon-pixel detector prototypes.…
We are now developing new X-ray imaging system by using Silicon-On-Insulator (SOI) Pixel Detectors. The SOI detector is a monolithic radiation imaging detector based on a 0.2um FD-SOI CMOS process. Special additional process steps are also…
This paper describes the data acquisition system used for data readout from a segmented detector of reactor antineutrinos with active shielding. Theoretical approach to the data acquisition is described and two possible solutions using QDCs…
Electronic systems for qubit control and measurement serve as a bridge between quantum programming language and quantum information processors. With the rapid development of superconducting quantum circuit (SQC) technology, synchronization…
Present state of the art applications in the area of high energy physics experiments (HEP), radar communication, satellite communication and bio medical instrumentation require fault resilient data acquisition (DAQ) system with the data…
We describe the hardware, gateware, and software developed at Raytheon BBN Technologies for dynamic quantum information processing experiments on superconducting qubits. In dynamic experiments, real-time qubit state information is fedback…
Meta-software for data acquisition (DAQ) is a new approach to design the DAQ systems for experimental setups in experiments in high energy physics (HEP). It abstracts from experiment-specific data processing logic, but reflects it through…
The Real-Time Systems Engineering Department of the Scientific Computing Division at Fermilab is developing a flexible, scalable, and powerful data-acquisition (DAQ) toolkit which serves the needs of experiments from bench-top hardware…
Microwave reflectometry is a non-intrusive plasma diagnostic tool which is widely applied in many fusion devices. In 2014, the microwave reflectometry on Experimental Advanced Superconducting Tokamak (EAST) had been upgraded to measure…
Caribou is a versatile data acquisition system used in multiple collaborative frameworks (CERN EP R&D, DRD3, AIDAinnova, Tangerine) for laboratory and test-beam qualification of novel silicon pixel detector prototypes. The system is built…
With the increasing physical event rate and number of electronic channels, traditional readout scheme meets the challenge of improving readout speed caused by the limited bandwidth of crate backplane. In this paper, a high-speed data…
We present a control and measurement setup for superconducting qubits based on Xilinx 16-channel radio-frequency system-on-chip (RFSoC) device. The proposed setup consists of four parts: multiple RFSoC boards, a setup to synchronise every…
Data acquisition systems for the accelerator complex at SRRC composed various hardware and software components. Beam signals are processed by related processing electronics, and connect to control system by various type of interfaces in…
In this paper, we design a PXI-based, multi-channel data-acquisition system (DAS) mainly applicable to recording one-shot fast transient pulses in nuclear physics experiments. The system consists of one NI PXIe-1085 chassis, containing a…
In Phase II of the Project 8 neutrino mass experiment, electrons from the decays of tritium or ${}^{83\mathrm{m}}$Kr are detected via their $\approx$26 GHz cyclotron radiation while contained within a circular waveguide. The signal from a…
A new $\mu$TCA DAQ system was introduced in CANDLES experiment with SpaceWire-to-GigabitEthernet (SpaceWire-GigabitEthernet) network for data readout and Flash Analog-to-Digital Converters (FADCs). With SpaceWire-GigabitEthernet, we can…
One of the optimization goals of a particle accelerator is to reach the highest possible beam peak current. For that to happen the electron bunch propagating through the accelerator should be kept relatively short along the direction of its…
We describe an FPGA based Front-End Data Acquisition Module (FEDAM) for implementing Time-over-Threshold (ToT) Time-to-Digital conversion (TDC) of pulses obtained from the COSMICi astroparticle telescope detector system photomultiplier…
The SPring-8 control system provides data acquisition software called Poller/Collector for periodic data taking. Its polling scheme does not support taking data synchronized with an event, and simultaneity in the data from the different VME…