Related papers: The TOTEM nT2 detector: architecture, operation an…

During LHC Long Shutdown 3, the ALICE experiment will replace the three innermost layers of its Inner Tracking System (ITS2) with a new vertex detector, the ITS3. This new detector will be assembled using wafer-scale, stitched Monolithic…

The neutron detection system for characterization of emissivity in ITER Tokamak during DD and DT experiments poses serious challenges to the performance of the diagnostic control and data acquisition system (CDAcq). The ongoing design of…

ALICE is one of the four experiments at the CERN Large Hadron Collider (LHC) specifically designed to study nuclear matter at extreme conditions of temperature and pressure. The LHC Run 3 started officially in July 2022 with proton-proton…

Production of the High Granularity Timing Detector for the ATLAS experiment at High Luminosity LHC requires over 21000 silicon sensors based on Low Gain Avalanche Diode (LGAD) technology. Their radiation hardness is monitored as a part of…

We have developed a non-collective Thomson scattering diagnostic for measurements of electron density and temperature on the Large Plasma Device. A triple grating spectrometer with a tunable notch filter is used to discriminate the faint…

The High-Acceptance DiElectron Spectrometer (HADES) at GSI Darmstadt consists of a 6-coil toroidal magnet centered on the beam axis and six identical detection sections located between the coils and covering polar angles between $18^\circ$…

MiniCACTUS-v2 is a monolithic sensor prototype designed in LF 150 nm CMOS process for time tagging of individual Minimum Ionizing Particles with an accuracy better than 100 ps. The sensing element is a deep n-well/p-substrate diode without…

The timing measurement of charged particles using silicon detector is widely used in synchrotron source as X-ray detectors, in time-of-flight mass spectrometer and especially in large collider experiment. To reduce the drastically event…

The existing ATLAS Tracker will be at its functional limit for particle fluences of 10^15 neq/cm^2 (LHC). Thus for the upgrades at smaller radii like in the case of the planned Insertable B-Layer (IBL) and for increased LHC luminosities…

Scintillating crystal detector may offer some potential advantages in the low-energy, low-background experiments. A 500 kg CsI(Tl) detector to be placed near the core of Nuclear Power Station II in Taiwan is being constructed for the…

The Semiconductor Tracker (SCT) is a silicon strip detector and one of the key precision tracking devices in the Inner Detector of the ATLAS experiment at CERN LHC. The completed SCT has been installed inside the ATLAS experimental cavern…

The next generation of very-short-baseline reactor experiments will require compact detectors operating at surface level and close to a nuclear reactor. This paper presents a new detector concept based on a composite solid scintillator…

Conventional reactor neutrino experiments are dissapearance experiments, and thus have less sensitivity to small mixing angles than appearance experiments do. It has been recently shown that future reactor neutrino experiments consisiting…

Measurements of polarized electron-nucleon scattering can be realized at the TESLA linear collider facility with projected luminosities that are about two orders of magnitude higher than those expected of other experiments at comparable…

A novel low-energy ($\sim$few keV) neutrino-oscillation experiment NOSTOS, combining a strong tritium source and a high pressure spherical Time Projection Chamber (TPC) detector 10 m in radius has been recently proposed. The oscillation of…

In this study, we developed a new proton detector system called CATCH, which was designed for a scattering experiment involving a $\Sigma$ hyperon and a proton (J-PARC E40). CATCH is a cylindrical detector system covering an inner target…

Thermal neutron total scattering experiments of light and heavy water were reproduced using the CSNS in-house Monte Carlo thermal neutron transport code, Prompt, with a focus on the instrumental detector response and the accurate derivation…

Silicon strip detectors developed for the Inner Tracker (ITk) of the ATLAS experiment will operate in a harsh radiation environment of the HL-LHC accelerator. The ITk is thus designed to endure a total fluence of 1.6E15 1MeV n_eq/cm2 and a…

The SoLid collaboration operates since 2018 a 1.6 ton neutrino detector at the Belgian BR2 reactor, with as main goal the search for the oscillation of electron anti-neutrinos to a sterile state. The highly segmented SoLid detector employs…

A new type of integrated temperature and humidity sensor applying LTCC-technology has been developed and characterized. In this approach, sensing elements are implemented using heated metal resistors (Pt-elements), where one is exposed to…