Related papers: Compact beam position monitor using a segmented to…
We present the design and performance of a non-imaging concentrator for use in broad-band polarimetry at millimeter through submillimeter wavelengths. A rectangular geometry preserves the input polarization state as the concentrator couples…
For precise start time determination a Beam Fragmentation T$_0$ Counter (BFTC) is under development for the Time-of-Flight Wall of the Compressed Baryonic Matter Spectrometer (CBM) at the Facility for Antiproton and Ion Research (FAIR) at…
Precision measurements in storage rings are increasingly limited by the ability to monitor collective spin dynamics coherently over long time scales. Existing polarimetry techniques rely on destructive scattering processes that preclude…
Controlling the in-band co-polarization scattering of the antenna while maintaining its radiation performance is crucial for the low observable platform. Thus, this paper studies the in-band co-polarization scattering beam scanning of…
The new beam position monitor (BPM) system of the injector at the upgrade project of Hefei Light Source (HLS II) has 19 stripline beam position monitors. Most consist of four orthogonal symmetric stripline electrodes. The differences in…
A novel modular high-resolution charged-particle tracking detector design using $250\mu m$ diameter, round, scintillating fibers and SiPM arrays for readout is presented. The fiber modules consist of 8 layers of 128 fibers, mechanically sta…
The resonant slow light structures created along a thin-walled optical capillary by nanoscale deformation of its surface can perform comprehensive simultaneous detection and manipulation of microfluidic components. This concept is…
A system for bunch-by-bunch detection of transverse proton and antiproton coherent oscillations in the Tevatron is described. It is based on the signal from a single beam-position monitor located in a region of the ring with large amplitude…
In order to achieve its ambitious luminosity target, the SuperKEKB collider must achieve and sustain high beam currents on the order of Ampere in its storage rings. This requires continuous top-up injection and operation with a two-bunch…
A beam monitor detector prototype based on doped silica fibres coupled to optical fibres has been designed, constructed and tested, mainly for accelerators used in medical applications. Scintillation light produced by Ce and Sb doped silica…
We discuss polarizing a proton beam in a storage ring, either by selective removal or by spin flip of the stored ions. Prompted by recent, conflicting calculations, we have carried out a measurement of the spin flip cross section in…
Inertial sensors that measure the acceleration of ultracold atoms promise unrivalled accuracy compared to classical equivalents. However, atomic systems are sensitive to various perturbations, including magnetic fields, which can introduce…
We report the development of a fast position-sensitive laser beam detector with a bandwidth that exceeds currently available detectors. The detector uses a fiber-optic bundle that spatially splits the incident beam, followed by a fast…
We report the realization of a bonded-bridge on-chip superconducting coil and its use in impedance-matching a highly ohmic quantum dot (QD) to a $\rm{3~GHz}$ measurement setup. The coil, modeled as a lumped-element $LC$ resonator, is more…
Compact inductor-capacitor (LC) resonators, in contrast to coplanar waveguide (CPW) resonators, have a simple lumped-element circuit representation but usually call for sophisticated finite-element method (FEM) simulations for an accurate…
A quantum device for measuring two-body interactions, scalar magnetic fields and rotations is proposed using a Bose--Einstein condensate (BEC) in a ring trap. We consider an imbalanced superposition of orbital angular momentum modes with…
We report results on a tracking performance study performed using a beam telescope made of 50 micron-thick CMOS pixel sensors on the 1.5 GeV electron beam at the LBNL ALS.
This paper presents the design and results of detailed tests of a CMOS active pixel chip for charged particle detection with in-pixel charge storage for correlated double sampling and readout in rolling shutter mode at frequencies up to 25…
We report the design, operation and performance of a high-resolution, low-latency, bunch-by-bunch feedback system for nano-beam stabilisation. The system employs novel, ultra-low quality-factor cavity beam position monitors (BPMs), a…
We describe a study of high-energy Compton beam polarimeters for the future e+e- linear collider machine TESLA. A segment of the beam delivery system has been identified, which is aligned with the e+e- collision axis and which has a…