Related papers: Thermal spectrometer for superconducting circuits
The study of quantum heat transport in superconducting circuits is significant for further understanding the connection between quantum mechanics and thermodynamics, and for possible applications for quantum information. The first…
Manipulating the electromagnetic spectrum at the single-photon level is fundamental for quantum experiments. In the visible and infrared range, this can be accomplished with atomic quantum emitters, and with superconducting qubits such…
It has always been a challenge for researchers to efficiently and accurately post process experimental data which is distorted by the noise. Superconducting microwave devices e.g. resonators, directional filters, beam-splitters etc. operate…
Cyclic voltammetry (CV) is a powerful technique for characterizing electrochemical properties of electrochemical devices. During charging-discharging cycles, thermal effect has profound impact on its performance, but existing theoretical…
Radio-frequency (RF) reflectometry is widely used for high-bandwidth readout of semiconductor quantum devices at cryogenic temperatures, but its application has mainly been limited to nanoscale structures with relatively small capacitances.…
Highly disordered superconductors, in the magnetic-field-driven insulating state, can show discontinuous current-voltage characteristics. Electron overheating has been shown to give a consistent description of this behavior, but there are…
The paper describes a radio frequency (RF) spectrometer for 14N nuclear quadrupole resonance (NQR) spectroscopy that uses a detector coil cooled to 77 K to maximize measurement sensitivity. The design uses a minimally-intrusive network of…
Superconducting microcalorimeters, such as superconducting transition-edge sensors and magnetic microcalorimeters, have emerged as state-of-the-art detectors for X-ray emission spectroscopy by combining near-unity quantum efficiency with…
Resonant laser spectroscopy of a negatively charged self-assembled quantum dot is utilized to measure the temperature of a three dimensional fermionic reservoir down to 100mK. With a magnetic field applied to the quantum dot the single…
Motivated by the recent development of fast and ultra-sensitive thermometry in nanoscale systems, we investigate quantum calorimetric detection of individual heat pulses in the sub-meV energy range. We propose a hybrid superconducting…
We present the design of a continuous-wave, highly sensitive optical spectrometer for millimeter-wave frequencies between 50 and 1000 GHz. The spectrometer uses photomixing of near-infrared light to generate radiation in a wide frequency…
Uncooled InfraRed (IR) detectors have enabled the rapid growth of thermal imaging applications. These detectors are predominantly bolometers, where the heating of pixel from incoming IR radiation is read out as a resistance change. Another…
Coplanar waveguide resonators are central to the thriving field of circuit quantum electrodynamics. Recently, we have demonstrated the generation of a broadband microwave-frequency comb spectrum using a superconducting quantum interference…
A novel room temperature capacitance-to-phase transducer is described, which uses a modified All-Pass filter architecture combined with a simple series resonant tank circuit with a moderate Q-factor. It is fashioned from a discrete inductor…
The complex ac impedance of a bolometer or microcalorimeter detector is easily measured and can be used to determine thermal time constants, thermal resistances, heat capacities, and sensitivities. Accurately extracting this information…
We designed and successfully fabricated an absorption-type of superconducting coplanar waveguide (CPW) resonators. The resonators are made from a Niobium film (about 160 nm thick) on a high-resistance Si substrate, and each resonator is…
This work focuses on the development and demonstration of tunable superconducting on-chip resonator, leveraging the intrinsic current-dependent non-linear kinetic inductance of superconducting aluminium, and investigating the effect of…
We have developed a transient thermoreflectance technique using picosecond pulsed and cw laser to study thermal conductivity and interface conductance in both thin-films and bulk materials. A real time-resolved system observes a thermal…
Measuring the internal quality factor of coplanar waveguide superconducting resonators is an established method of determining small losses in superconducting devices. Traditionally, the resonator losses are only attributed to two-level…
The method consists in the monitoring of the temperature variation of a superconductor tape subjected to a trapezoidal current pulse. Simulations of the experiment were performed using the lumped capacitance model and also the finite…