Related papers: Fundamentals of Energy-Efficient Wireless Links: O…
This paper studies the energy efficiency and sum rate trade-off for coordinated beamforming in multi-cell multi-user multigroup multicast multiple-input single-output systems. We first consider a conventional network energy efficiency…
Radio frequency (RF) wireless power transfer (WPT) is a promising technology for charging the Internet of Things. Practical RF-WPT systems usually require energy beamforming (EB), which can compensate for the severe propagation loss by…
The use of large-scale antenna arrays can bring substantial improvements in energy and/or spectral efficiency to wireless systems due to the greatly improved spatial resolution and array gain. Recent works in the field of massive…
One of the most important challenges in the fifth generation (5G) of telecommunication systems is the efficiency of energy and spectrum. Massive multiple-input multiple-output (MIMO) systems have been proposed by researchers to resolve…
Wireless Energy Transfer (WET) is emerging as a potential green enabler for massive Internet of Things (IoT). Herein, we analyze Channel State Information (CSI)-free multi-antenna strategies for powering wirelessly a large set of…
As an emerging flexible antenna technology for wireless communications, pinching-antenna systems, offer distinct advantages in terms of cost efficiency and deployment flexibility. This paper investigates joint transmission strategies of the…
In this paper, we study the energy efficiency (EE) maximization problem in multiple-input multiple-output (MIMO) two-way relay networks with simultaneous wireless information and power transfer (SWIPT). The network consists of a…
The performance of remote estimation over wireless channel is strongly affected by sensor data losses due to interference. Although the impact of interference can be alleviated by performing spectrum sensing and then transmitting only when…
Hybrid beamforming (HBF) and antenna selection are promising techniques for improving the energy efficiency~(EE) of massive multiple-input multiple-output~(mMIMO) systems. However, the transmitter architecture may contain several parameters…
In this paper, we study the optimal waveform design for wireless power transfer (WPT) from a multi-antenna energy transmitter (ET) to multiple single-antenna energy receivers (ERs) simultaneously in multi-path frequency-selective channels.…
Effective Capacity defines the maximum communication rate subject to a specific delay constraint, while effective energy efficiency (EEE) indicates the ratio between effective capacity and power consumption. We analyze the EEE of…
Wireless power transfer (WPT) has garnered increasing attention due to its potential to eliminate device-side batteries. With the advent of (distributed) multiple-input multiple-output (MIMO), radio frequency (RF) WPT has become feasible…
In this paper, we study the key properties of multi-antenna two-tier networks under different system configurations. Based on stochastic geometry, we derive the expressions and approximations for the users' average data rate. Through the…
Wireless nodes in future communication systems need to overcome three barriers when compared to their transitional counterparts, namely to support significantly higher data rates, have long-lasting energy supplies and remain fully…
Ambient radio frequency (RF) energy harvesting (EH) technology is key to realize self-sustainable, always-on, low-power, massive Internet of Things networks. Typically, rigid (non-adaptable to channel fluctuations) multi-antenna receive…
This paper studies the training design problem for multiple-input single-output (MISO) wireless energy transfer (WET) systems in frequency-selective channels, where the frequency-diversity and energy-beamforming gains can be both reaped to…
This paper considers wireless uplink information and downlink power transfer in cell-free massive multiple-input multiple-output systems. The single-antenna user equipments (UEs) utilize the energy harvested in the downlink to transmit…
This paper considers a single-cell massive multiple-input multiple-output (MIMO) system equipped with a base station (BS) that uses one-bit quantization and investigates the energy efficiency (EE) and spectral efficiency (SE) trade-off. We…
The spectral and energy efficiency (SE-EE) trade-off in pinching-antenna systems (PASS) is investigated in this paper. In particular, two practical operating protocols, namely waveguide multiplexing (WM) and waveguide switching (WS), are…
As wireless connectivity continues to evolve towards 6G, there is an ever-increasing demand to not only deliver higher throughput, lower latency, and improved reliability, but also do so as efficiently as possible. To this point, the term…