Related papers: Freezing receding contact lines
Falling liquid films become unstable due to inertial effects when the fluid layer is sufficiently thick or the slope sufficiently steep. This free surface flow of a single fluid layer has industrial applications including coating and heat…
A solid-liquid-gas moving contact line is considered through a diffuse-interface model with the classical boundary condition of no-slip at the solid surface. Examination of the asymptotic behaviour as the contact line is approached shows…
The complex behavior of drop deposition on a hydrophobic surface is considered by looking at a model problem in which the evolution of a constant-volume liquid bridge is studied as the bridge is stretched. The bridge is pinned with a fixed…
Droplet deposition onto a hydrophobic surface is studied experimentally and numerically. A wide range of droplet sizes can result from the same syringe, depending strongly on the needle retraction speed. Three regimes are identified…
The flow near a moving contact line is primarily governed by three key parameters: viscosity ratio, dynamic contact angle, and inertia. While the behavior of dynamic contact angles has been extensively studied in earlier experimental and…
We systematically study the meniscus on the outside of a small circular cylinder vertically immersed in a liquid bath in a cylindrical container that is coaxial with the cylinder. The cylinder has a radius $R$ much smaller than the…
In 1805, Young was the first who introduced an expression for contact angle in static, but today, the motion of the contact-line formed at the intersection of two immiscible fluids and a solid is still subject to dispute. By means of the…
In this paper, we report experimental results on the shape and motion of a mercury droplet, placed in a horizontally rotating cylinder in the rpm range 8-93, so that the Reynolds number of the drop 2500<Re<26000 and its capillary number…
We propose a generic model for thin films and shallow drops of a polar active liquid that have a free surface and are in contact with a solid substrate. The model couples evolution equations for the film height and the local polarization…
We have used the density-functional theory to locate the freezing transitions and calculate the values of freezing parameters for a system of long elongated molecules which interact via the Gay-Berne pair potential. The pair correlation…
Drops deposited on an evaporating liquid bath can be maintained in an inverse Leidenfrost state by the vapor emanating from the bath, making them levitate and hover almost without friction. These perfectly non-wetting droplets create a…
We provide an ab-initio scaling analysis for liquid film thickness and Nusselt number of a steady laminar jet impacting a rotating heated plate. The limiting scaling regimes incorporating the evaporative effects along the liquid-vapor…
The moving contact-line problem is of both theoretical and practical interest. The dynamic contact angle changes with the capillary number defined by the contact-line speed, and the correlation also depends on the equilibrium contact angle…
In an effort to study the stability of contact lines in fluids, we consider the dynamics of a drop of incompressible viscous Stokes fluid evolving above a one-dimensional flat surface under the influence of gravity. This is a free boundary…
We consider capillary condensation transitions occurring in open slits of width $L$ and finite height $H$ immersed in a reservoir of vapour. In this case the pressure at which condensation occurs is closer to saturation compared to that…
We study the equilibrium properties and the wetting behavior of a simple liquid on a polymer brush, with and without presence of lubricant by multibody Dissipative Particle Dynamics simulations. The lubricant is modelled as a polymeric…
After thrown onto a solid substrate, very soft spherical gels bounce repeatedly. Separate rheological measurements suggest that these balls can be treated as nearly elastic. The Hertz contact deformation expected in the static (elastic)…
We studied experimentally the breakup of liquid bridges made of aqueous solutions of Poly(acrylic acid) between two separating solid surfaces with freely moving contact lines. For polymer concentrations higher than a certain threshold…
In an effort to study the stability of contact lines in fluids, we consider the dynamics of an incompressible viscous Stokes fluid evolving in a two-dimensional open-top vessel under the influence of gravity. This is a free boundary…
This paper is dedicated to the solidification of a water drop impacting a cold solid surface. In a first part, we establish a 1D solidification model, derived from the Stefan problem, that aims at predicting the freezing dynamic of a liquid…