Related papers: Concept Study of a Storage Ring-based Gravitationa…
We simulate the response of a Storage Ring Gravitational-Wave Observatory (SRGO) to astrophysical millihertz (mHz) gravitational waves (GWs), numerically obtaining its sensitivity curve and optimal choices for some controllable experiment…
A major challenge for gravitational-wave (GW) detection in the $\mu$Hz band is engineering a test mass (TM) with sufficiently low acceleration noise. We propose a GW detection concept using asteroids located in the inner Solar System as…
The gravitational waveform of merging binary neutron stars encodes information about extreme states of matter. Probing these gravitational emissions requires the gravitational-wave detectors to have high sensitivity above 1 kHz. Fortunately…
The most promising concept for low frequency gravitational wave observatories are laser interferometric detectors in space. It is usually assumed that the noise floor for such a detector is dominated by optical shot noise in the signal…
Gravitational wave (GW) detection in space is aimed at low frequency band (100 nHz - 100 mHz) and middle frequency band (100 mHz - 10 Hz). The science goals are the detection of GWs from (i) Supermassive Black Holes; (ii) Extreme-Mass-Ratio…
The binary neutron star coalescence GW170817 was observed by gravitational wave detectors during the inspiral phase but sensitivity in the 1-5 kHz band was insufficient to observe the expected nuclear matter signature of the merger itself,…
Gravitational Waves (GWs) have been detected in the $\sim$100 Hz and nHz bands, but most of the gravitational spectrum remains unobserved. A variety of detector concepts have been proposed to expand the range of observable frequencies. In…
The fast progress in improving the sensitivity of the gravitational-wave (GW) detectors, we all have witnessed in the recent years, has propelled the scientific community to the point, when quantum behaviour of such immense measurement…
A recent proposal describes space based gravitational wave (GW) detection with optical lattice atomic clocks [Kolkowitz et. al., Phys. Rev. D 94, 124043 (2016)] [1]. Based on their setup, we propose a new measurement method for…
The LIGO observatories detect gravitational waves through monitoring changes in the detectors' length down to below $10^{-19}$\,$m/\sqrt{Hz}$ variation---a small fraction of the size of the atoms that make up the detector. To achieve this…
We reinvestigate the gravitational waves (GWs) induced by charged particles in storage rings. There are two major components in such GWs. One is the gravitational synchrotron radiation (GSR), i.e., the direct emission by the bending of the…
We propose a data processing technique that allows searches for a stochastic background of gravitational radiation with data from a single detector. Our technique exploits the difference between the coherence time of the gravitational wave…
We consider a recent scheme of gravitational wave detection using atomic interferometers as inertial sensors, and reinvestigate its configuration using the concept of sensitivity functions. We show that such configuration can suppress noise…
In the coming years gravitational-wave detectors will undergo a series of improvements, with an increase in their detection rate by about an order of magnitude. Routine detections of gravitational-wave signals promote novel astrophysical…
Data from gravitational wave detectors are recorded as time series that include contributions from myriad noise sources in addition to any gravitational wave signals. When regularly sampled data are available, such as for ground based and…
We evaluate the potential for gravitational-wave (GW) detection in the frequency band from 10 nHz to 1 $\mu$Hz using extremely high-precision astrometry of a small number of stars. In particular, we argue that non-magnetic, photometrically…
Disturbances in gravitational wave (GW) observational data are often caused by non-stationary noise in the detector itself, such as back-scattering of laser stray light into the signal field. Unlike GW signals, non-stationary noise can…
We propose a new detection strategy for gravitational waves (GWs) below few Hertz based on a correlated array of atom interferometers (AIs). Our proposal allows to reduce the Newtonian Noise (NN) which limits all ground based GW detectors…
We propose two distinct atom interferometer gravitational wave detectors, one terrestrial and another satellite-based, utilizing the core technology of the Stanford $10 \text{m}$ atom interferometer presently under construction. The…
We quantify the advantages of a recently proposed data processing technique to search for continuous gravitational wave (GW) signals from isolated rotating asymmetric neutron stars in data measured by ground-based GW interferometers. This…