Related papers: Development and Characterization of a Novel BaTiO3…
Ultra-high temperature ceramics (UHTCs) are promising materials for use in next-generation aerospace structures but have primarily been used as monolithic materials or coatings due to processing limitations. Here, new functionality (e.g.,…
The properties of Pt-based materials can be intriguing due to the importance of spin-orbit coupling for Pt. Herein, we report four new phases with formulas M3Pt23Ge11 (M = Ca, Sr, Ba and Eu), which adopt the same structure type as…
Thin film BaTiO$_3$ has one of the highest known Pockels coefficients (>1200 pm/V), making it an attractive material for use in electro-optic devices. It is advantageous to integrate BaTiO$_3$ on silicon to enable complementary…
Critical temperature Tc of the Li2(Pd1-xPtx)3B was reported to be 7-8K for x=0 and 2.2-2.8K for x=1. In this article we present our preliminary results on behavior of magnetization-temperature curves with starting composition of Pd-B…
We have discovered that samples of a new material produced by special processing of crystals of Sr2RuO4 (which is known to be a triplet superconductor with Tc values ~1.0-1.5K) exhibit signatures of superconductivity (zero DC resistance and…
The discovery of high temperature superconductivity in cuprates was possible only through an intimate knowledge of perovskite oxides which have been synthesized and characterized for decades at the IBM in the Z\"urich laboratoty. Especially…
The ultra-wide bandgap, high breakdown electric field, and large-area affordable substrates make \b{eta}-Ga2O3 promising for applications of next-generation power electronics while its thermal conductivity is at least one order of magnitude…
CaCu3Ti4O12 (CCTO) ceramics which has perovskite structure gained considerable attention due to its giant permittivity. But, it has high tan {\delta} (0.1 at 1kHz) at room temperature, which needs to be minimised to the level of practical…
Lithium doped sodium niobate is an ecofriendly piezoelectric material that exhibits a variety of structural phase transitions with composition and temperature. We have investigated the phase stabilities of an important composition…
The present work explores the suitability of Al-Cu-Si ternary alloys as hightemperature metallic phase change materials (PCMs) for thermal energy storage systems (TESS) operating between 550__C and 850__C. While prior research has primarily…
Thermal conductivities are routinely calculated in molecular dynamics simulations by keeping the boundaries at different temperatures and measuring the slope of the temperature profile in the bulk of the material, explicitly using Fourier's…
To examine the thermodynamic properties of Pr$_{2}$Ba$_{4}$Cu$_{7}$O$_{15-\delta }$ compounds with metallic CuO double chains, we measured the specific heats of superconducting and non-superconducting polycrystalline samples at low…
The measured value of effective electric permittivity \varepsilon_{eff} of several compounds, e.g., (BiNa)(MnNb)O_{3}, (BiPb)(MnNb)O_{3}, and BiMnO_{3} increases from a value \approx 10-100 at the low temperature range (100-300 K) up to the…
The remarkable finding of this work is the linear correlation between the critical temperature of superconducting (SC) transition, Tc, and the room-temperature half-width of angular correlation of positron annihila- tion phonons (ACPAP),…
Silicon Carbide (SiC) is a typical material for third-generation semiconductor. The thermal boundary resistance (TBR) of 4H-SiC/SiO2 interface, was investigated by both experimental measurements and theoretical calculations. The structure…
We report an experimental discovery of CrSnS3, a new Van der Waals ferromagnetic (FM) with Curie temperature TC ~119K. The Curie temperature is in qualitative agreement of Chittari et. al. DFT prediction (TC =112.3K) for an Ising model with…
Temperature dependence of electrical resistance of single-walled carbon nanotube (SWCNTs)/epoxy nanocomposites, which is characterized by a temperature coefficient of resistance (TCR), is experimentally investigated. In the existing…
This study presents a computational framework to investigate and predict the complicated multiphase properties of eco-friendly lead-free piezoelectric materials, which are crucial for sustainable technological progress. Although their…
This study presents a machine learning approach to predict the Curie temperature in binary alloys, specifically focusing on the Fe-Pt, Fe-Ni, Fe-Pd, and Co-Pt compounds within a concentration range of 10 to 90 atomic percent. The optimal…
The cubic perovskite-related ceramic CaCu3Ti4O12 has a very high static dielectric constant ~10000 at room temperature (RT), which drops to about 100 below about 100 K. Substituting Cd for Ca reduces the RT value of the dielectric constant…