Related papers: Slip Length in Shear Flow Over a Textured Surface
We simulate a dense athermal suspension of soft particles sheared between hard walls of a prescribed roughness profile, using a method that fully accounts for the fluid mechanics of the solvent between the particles, and between the…
We calculate the effective slip length for a rectangularly grooved periodic surface encapsulated (i.e., fully wetted) by a lubricant fluid and subjected to exterior shear flow parallel to the grooves. Our focus is the limit of a…
The turbulent flow within and above a sparse canopy is investigated using direct numerical simulations. The balance of Reynolds to viscous stresses within the canopy is observed to be similar to that over a smooth wall. From this, a scaling…
On microstructured hydrophobic surfaces, geometrical patterns may lead to the appearance of a superhydrophobic state, where gas bubbles at the surface can have a strong impact on the fluid flow along such surfaces. In particular, they can…
Patterned surfaces with large effective slip lengths, such as super-hydrophobic surfaces containing trapped gas bubbles, have the potential to reduce hydrodynamic drag. Based on lubrication theory, we analyze an approach of a hydrophilic…
We employ a multi-phase smoothed particle hydrodynamics (SPH) method to study droplet dynamics in shear flow. With an extensive range of Reynolds number, capillary number, wall confinement, and density/viscosity ratio between the droplet…
Superhydrophobic surfaces (SHS) are textured hydrophobic surfaces which have the ability to trap air pockets when immersed in water. This can result in significant drag reduction, due to substantially lower viscosity of air resulting in…
The present study provides a detailed description of the forces on an ellipsoidal particle in the vicinity of the rough wall. Three-dimensional numerical simulations are performed using body-fitted mesh to estimate the drag, lift, and…
This study investigates the nonlinear stability and dynamics of gravity-driven viscous films on a vertical rotating cylinder, considering both outer and inner surface flows with slip conditions at the cylinder wall. We develop an asymptotic…
Wall modelling in large-eddy simulation (LES) is necessary to overcome the prohibitive near-wall resolution requirements in high-Reynolds-number turbulent flows. Most existing wall models rely on assumptions about the state of the boundary…
Slippage of Newtonian liquids in the presence of a solid substrate is a newly found phenomenon the origin of which is still under debate. In this paper, we present a new analysis method to extract the slip length. Enhancing the slip of…
We provide general derivations of the partial slip boundary condition from microscopic dynamics and linearized fluctuating hydrodynamics. The derivations are based on the assumption of separation of scales between microscopic behavior, such…
The modeling of surface pressure wave number spectra beneath a turbulent boundary layer is reviewed and reconsidered in terms of the vorticity in the flow. Using a solution based on the vorticity equation and Squires theorem, which was…
We consider the flow of a Newtonian fluid in a nano or microchannel with walls that have patterned variations in slip length. We formulate a set of equations to describe the effects on an incompressible Newtonian flow of small variations in…
Wall slip and wall divergence are known to have large and opposing effects on the stability of flow in a two-dimensional channel. While divergence hugely destabilises, slip dramatically stabilizes the linear mode. In a non-parallel…
Recent experiments (Zhu & Granick (2001) Phys. Rev. Lett. 87 096105) have measured a large shear dependent fluid slip at partially wetting fluid-solid surfaces. We present a simple model for such slip, motivated by the recent observations…
The underlying mechanisms of three different flow-control strategies on drag reduction in a channel flow are investigated by direct numerical simulations at friction Reynolds numbers ranging from 65 to 85. These strategies include the…
The flow above idealized, two-dimensional series of parallelepipedal buildings is examined with the aim of investigating how the building width to height aspect ratio affects the turbulence in the roughness sublayer and the ventilation of…
The effect of random surface roughness on hydrodynamics of viscous incompressible liquid is discussed. Roughness-driven contributions to hydrodynamic flows, energy dissipation, and friction force are calculated in a wide range of…
Shear flow is known to induce huge density fluctuations in otherwise clear and uniform polymer solutions. This effect is rooted in the elasticity of the entangled polymer network, and can span distances over a thousand chains wide. It has…