Related papers: OFDM-Based Positioning with Unknown Data Payloads:…
A novel method for correcting the effect of nonlinear distortion in orthogonal frequency division multiplexing signals is proposed. The method depends on adaptively selecting the distortion over a subset of the data carriers, and then using…
With the large number of antennas and subcarriers the overhead due to pilot transmission for channel estimation can be prohibitive in wideband massive multiple-input multiple-output (MIMO) systems. This can degrade the overall spectral…
Origin-Destination Matrix (ODM) estimation is a classical problem in transport engineering aiming to recover flows from every Origin to every Destination from measured traffic counts and a priori model information. In addition to traffic…
The computation of positioning, navigation and timing (PNT) via signal of opportunity (SOP), where signals originally transmitted for communication, such as 5G, Wi-Fi, or DVB-S, are exploited due to their ubiquity and spectral…
High-mobility scenarios will be a critical part of 6G systems. Since the widely deployed orthogonal frequency division multiplexing (OFDM) waveform suffers from subcarrier orthogonality loss under severe Doppler spread, delay-Doppler domain…
The problem of off-grid direction-of-arrival (DOA) estimation is investigated. We develop a grid-based method to jointly estimate the closest spatial frequency (the sine of DOA) grids, and the gaps between the estimated grids and the…
Millimeter-wave (mmWave) communication is a promising solution for achieving high data rate and low latency in 5G wireless cellular networks. Since directional beamforming and antenna arrays are exploited in the mmWave networks, accurate…
The localization of directional RF emitters presents significant challenges for electronic warfare applications. Traditional localization methods, designed for omnidirectional emitters, experience degraded performance when applied to…
Future wireless communication systems must simultaneously address multiple challenges to ensure accurate data detection, deliver high Quality of Service (QoS), adding enable a high data transmission with low system design. Additionally,…
This study explores the promising potential of integrating sensing capabilities into multiple-input multiple-output (MIMO)-orthogonal frequency division multiplexing (OFDM)-based networks through innovative multi-sensor fusion techniques,…
Separating sources is a common challenge in applications such as speech enhancement and telecommunications, where distinguishing between overlapping sounds helps reduce interference and improve signal quality. Additionally, in multichannel…
In this paper, we investigate the performance gains of adapting pilot spacing and power for Carrier Aggregation (CA)-OFDM systems in nonstationary wireless channels. In current multi-band CA-OFDM wireless networks, all component carriers…
Low Earth orbit (LEO) satellites offer a promising alternative to global navigation satellite systems for precise positioning; however, their relatively low altitudes make them more susceptible to orbital perturbations, which in turn…
This paper presents an analysis of target localization accuracy, attainable by the use of MIMO (Multiple-Input Multiple-Output) radar systems, configured with multiple transmit and receive sensors, widely distributed over a given area. The…
Noise characterization for pulsar-timing applications accounts for interstellar dispersion by assuming a known frequency-dependence of the delay it introduces in the times of arrival (TOAs). However, calculations of this delay suffer from…
The focus of this letter is on the reduction of the large pilot overhead in orthogonal frequency division multiplexing (OFDM) based massive multiple-input multiple-output (MIMO) systems. We propose a novel joint channel estimation and…
We derive the closed form Cramer-Rao bound (CRB) expressions for joint estimation of time delay and Doppler shift with unknown signals with possibly known structure. The results are especially useful for passive radar where direct path and…
Orthogonal Frequency-Division Multiplexing (OFDM) is widely used in modern wireless communication systems due to its robustness against time-dispersive channels. In this work, we consider a non-cooperative scenario where the receiver does…
Automated plankton recognition models face significant challenges during real-world deployment due to distribution shifts (Out-of-Distribution, OoD) between training and test data. This stems from plankton's complex morphologies, vast…
An unknown-position sensor can be localized if there are three or more anchors making time-of-arrival (TOA) measurements of a signal from it. However, the location errors can be very large due to the fact that some of the measurements are…