Related papers: Access Point Selection for Bistatic Backscatter Co…
This paper presents a framework for target detection and downlink data transmission in a repeater-assisted bi-static integrated sensing and communication system. A repeater is an active scatterer that retransmits incoming signals with a…
Next-generation wireless networks are expected to develop a novel paradigm of integrated sensing and communications (ISAC) to enable both the high-accuracy sensing and high-speed communications. However, conventional mono-static ISAC…
In the sixth-generation (6G) networks, massive low-power devices are expected to sense environment and deliver tremendous data. To enhance the radio resource efficiency, the integrated sensing and communication (ISAC) technique exploits the…
Unmanned aerial vehicle (UAV) has been widely adopted in wireless systems due to its flexibility, mobility, and agility. Nevertheless, a limited onboard battery greatly hinders UAV to prolong the serving time from communication tasks that…
In 6G networks, integrated sensing and communication (ISAC) is envisioned as a key technology that enables wireless systems to perform joint sensing and communication using shared hardware, antennas and spectrum. ISAC designs facilitate…
Optimizing energy efficiency (EE) for the MIMO broadcasting channels (BC) is considered in this paper, where a practical power model is taken into account. Although the EE of the MIMO BC is non-concave, we reformulate it as a quasiconcave…
Prior works have explored multi-armed bandit (MAB) algorithms for the selection of optimal beams for millimeter-wave (mmW) communications between base station and mobile users. However, when the number of beams is large, the existing MAB…
Next-generation wireless networks are projected to empower a broad range of Internet-of-things (IoT) applications and services with extreme data rates, posing new challenges in delivering large-scale connectivity at a low cost to current…
Multiple-input multiple-output (MIMO) technology has been regarded as one of the most important technologies to enable emerging applications in current and next generation wireless communication systems, for which signal detection methods…
Practical ISAC is constrained by static clutter and NLoS multipath, which obscure target-coupled echoes and induce spurious peaks for beam alignment. Existing receiver-side methods largely model targets as passive scatterers, limiting the…
We consider multi-group multicast precoding designs for cell-free massive multiple-input multiple-output (MIMO) systems. To optimize the transmit and receive beamforming strategies, we focus on minimizing the sum of the maximum mean squared…
In this work, we consider a cell-free massive multiple-input multiple-output (MIMO) integarted sensing and communications (ISAC) system with maximum-ratio transmission schemes combined with multistatic radar-type sensing. Our focus lies on…
A communication setup is considered where a transmitter wishes to convey a message to a receiver and simultaneously estimates the state of that receiver through a common waveform. The state is estimated at the transmitter by means of…
This paper considers joint beamformer design towards maximizing the mutual information in a coherent wireless sensor network with noisy observation and multiple antennae. Leveraging the weighted minimum mean square error and block…
Integrated sensing and communication (ISAC) is an enabling technology for the sixth-generation mobile communications, which equips the wireless communication networks with sensing capabilities. In this paper, we investigate transmit…
We focus on a two-receiver Multiple-Input-Multiple-Output (MIMO) Broadcast Channel (BC) and Interference Channel (IC) with an arbitrary number of antennas at each node. We assume an imperfect knowledge of local Channel State Information at…
This paper studies an integrated sensing and communication (ISAC) system where a multi-antenna base station (BS) aims to communicate with a single-antenna user in the downlink and sense the unknown and random angle parameter of a target via…
Future Internet-of-Things (IoT) is expected to wirelessly connect billions of low-complexity devices. For wireless information transfer (WIT) in IoT, high density of IoT devices and their ad hoc communication result in strong interference…
Extending recent findings on the two-user MISO broadcast channel (BC) with imperfect and delayed channel state information at the transmitter (CSIT), the work here explores the performance of the two user MIMO BC and the two user MIMO…
Block diagonalization (BD) is a practical linear precoding technique that eliminates the inter-user interference in downlink multiuser multiple-input multiple-output (MIMO) systems. In this paper, we apply BD to the downlink transmission in…