Related papers: Multi-Objective Distributed Beamforming Using High…
Non-terrestrial base stations (NTBSs), including high-altitude platform stations (HAPSs) and hot-air balloons (HABs), are integral to next-generation wireless networks, offering coverage in remote areas and enhancing capacity in dense…
Beamformers often trade off white noise gain against the ability to suppress interferers. With distributed microphone arrays, this trade-off becomes crucial as different arrays capture vastly different magnitude and phase differences for…
In this paper we present a novel beamforming technique that can be used with an array of quantum sensors. The transmit waveform is a short-duration frequency comb constructed using a finite number of sinusoidal tones separated by a fixed…
Intelligent Transportation Systems (ITSs) require ultra-low end-to-end delays and multi-gigabit-per-second data transmission. Millimetre Waves (mmWaves) communications can fulfil these requirements. However, the increased mobility of…
In a cell-free wireless network, distributed access points (APs) jointly serve all user equipments (UEs) within the their coverage area by using the same time/frequency resources. In this paper, we develop a novel downlink cell-free…
A near-field wideband communication system is investigated in which a base station (BS) employs an extra-large scale antenna array (ELAA) to serve multiple users in its near-field region. To facilitate near-field multi-user beamforming and…
It is well known that there is inherent radiation pattern distortion for the commercial base station antenna array, which usually needs three antenna sectors to cover the whole space. To eliminate pattern distortion and further enhance…
Beamforming and precoding/combining are techniques aimed at processing multiantenna signals at the transmitter and/or at the receiver of a wireless communication system. While they have been routinely used to improve performance in current…
Network management is a fundamental ingredient for efficient operation of wireless networks. With increasing bandwidth, number of antennas and number of users, the amount of information required for network management increases…
High-mobility adaption and massive Multiple-input Multiple-output (MIMO) application are two primary evolving objectives for the next generation high speed train communication system. In this paper, we consider how to design a…
Providing guaranteed quality of service for cell-edge users remains a longstanding challenge in wireless networks. While coordinated interference management was proposed decades ago, its potential has been limited by computational…
A flexible wave localization is investigated using a spatial-temporal modulation of point defects along the periodic array of electromechanical local resonators of a piezoelectric bimorph beam. By changing the electrical resonance of…
We investigate multi-objective adaptive beamformer design strategies for non-invasive microwave hyperthermia. Our focus is to address the challenges of maintaining focused power deposition in desired locations while reducing unwanted…
For millimeter-wave (mmWave) non-orthogonal multiple access (NOMA) communication systems, we propose an innovative near-field (NF) transmission framework based on dynamic metasurface antenna (DMA) technology. In this framework, a base…
Recent developments in Phased Array direct positioning methods have improved accuracy for passively geo-locating multiple radio frequency-emitting signal sources. However, the number of geo-localisable signal sources is still limited by the…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
We study distributed algorithms for adjusting beamforming vectors and receiver filters in multiple-input multiple-output (MIMO) interference networks, with the assumption that each user uses a single beam and a linear filter at the…
Devices in a device-to-device (D2D) network operating in sub-THz frequencies require knowledge of the spatial channel that connects them to their peers. Acquiring such high dimensional channel state information entails large overhead, which…
To circumvent the high path loss of mmWave propagation and reduce the hardware cost of massive multiple-input multiple-output antenna systems, full-dimensional hybrid beamforming is critical in 5G and beyond wireless communications.…
In traditional multiple-input multiple-output (MIMO) communication systems, the antenna spacing is often no smaller than half a wavelength. However, by exploiting the coupling between more closely-spaced antennas, a superdirective array may…