Related papers: Source-Independent Fault Detection Method for Tran…
This article proposes a source-independent method for detecting faults along Transmission Lines (TL) to reduce the protection issues arising from Inverter-Based Resources (IBRs). In the proposed method, high-frequency waves are sent from…
Conventional relays face challenges for transmission lines connected to inverter-based resources (IBRs). In this article, a single-ended intelligent protection of the transmission line in the zone between the grid and the PV farm is…
Integration of Inverter Based Resources (IBRs) which lack the intrinsic characteristics such as the inertial response of the traditional synchronous-generator (SG) based sources presents a new challenge in the form of analyzing the grid…
The increasing integration of Inverter-Based Resources (IBRs) is reshaping fault current characteristics, presenting significant challenges to traditional protection and fault location methods. This paper addresses a key limitation in fault…
Abnormal event detection is critical in the safe operation of power system. In this paper, using the data collected from phasor measurement units (PMUs), two methods based on Fisher random matrix are proposed to detect faults in power…
Uninterruptible power supply is the main motive of power utility companies that motivate them for identifying and locating the different types of faults as quickly as possible to protect the power system prevent complete power black outs…
Ground fault detection in inverter-based microgrid (IBM) systems is challenging, particularly in a real-time setting, as the fault current deviates slightly from the nominal value. This difficulty is reinforced when there are partially…
The widespread deployment of inverter-based resources (IBRs) renders distribution systems susceptible to transmission-level faults. This paper presents a comprehensive analysis of the impact of transmission-level faults on 3-phase and…
The paper presents algorithms to realize effectively and accurately the stepped-frequency waveform reflectometry (SFWR), i.e. the reflectometric technique based on the use of sinusoidal bursts. This technique is useful for monitoring the…
This paper proposes a Decision Tree (DT) based detection and classification of internal faults in a power transformer. The faults are simulated in Power System Computer Aided Design (PSCAD)/ Electromagnetic Transients including DC (EMTDC)…
Diagnosis of high impedance fault (HIF) is a challenge for nowadays distribution network protections. The fault current of a HIF is much lower than that of a normal load, and fault feature is significantly affected by fault scenarios. A…
Data driven transmission line fault location methods have the potential to more accurately locate faults by extracting fault information from available data. However, most of the data driven fault location methods in the literature are not…
Conventional relays encounter difficulties in protecting transmission lines (TLs) connected to converter-based energy sources (CBESs) due to the influence of power electronics on fault characteristics. This article proposes a single-ended…
This paper proposes an accurate High Impedance Fault (HIF) detection and isolation scheme in a power distribution network. The proposed schemes utilize the data available from voltage and current sensors. The technique employs multiple…
Motivated by the need to localise faults along electrical power lines, this paper adopts a frequency-domain approach to parameter estimation for an infinite-dimensional linear dynamical system with one spatial variable. Since the time of…
Arcing faults in low voltage (LV) distribution systems associated with arc-flash risk and potentially significant equipment damage are notoriously difficult to detect under some conditions. Especially so when attempting to detect using…
The fault characteristics of inverter-based resources (IBRs) are different from conventional synchronous generators. The fault response of IBRs is non-linear due to saturation states and mainly determined by fault ride through (FRT)…
This paper proposes a novel fault detector for digital relaying based on independent component analysis (leA). The index for effective detection is derived from independent components of fault current. The proposed fault detector reduces…
This paper summarizes the electromagnetic time reversal (EMTR) technique for fault location, and further numerically validates its effectiveness when the fault impedance is negligible. In addition, a specific EMTR model considering the…
Differing from synchronous generators (SGs), grid-forming inverter-based resources (GFM-IBRs) exhibit rapid variations in their output impedances during transmission line faults due to the overcurrent limitation. As a result, the source…