Related papers: Fault-tolerant Network Design for Bounded Delay Da…
Spectrum resources management of growing demands is a challenging problem and Cognitive Radio (CR) known to be capable of improving the spectrum utilization. Recently, Power Spectral Density (PSD) map is defined to enable the CR to reuse…
Railway Turnout Machines (RTMs) are mission-critical components of the railway transportation infrastructure, responsible for directing trains onto desired tracks. For safety assurance applications, especially in early-warning scenarios,…
We consider a power transmission system monitored with Phasor Measurement Units (PMUs) placed at significant, but not all, nodes of the system. Assuming that a sufficient number of distinct single-line faults, specifically pre-fault state…
Ready Mixed Concrete Delivery Problem (RMCDP) is a multi-objective multi-constraint dynamic combinatorial optimization problem. From the operational research prospective, it is a real life logistic problem that is hard to be solved with…
The receiver design for multi-input multi-output (MIMO) ultra-reliable and low-latency communication (URLLC) systems can be a tough task due to the use of short channel codes and few pilot symbols. Consequently, error propagation can occur…
Since some years ago, use of Feedback Control Scheduling Algorithm (FCSA) in the control scheduling co-design of multiprocessor embedded system has increased. FCSA provides Quality of Service (QoS) in terms of overall system performance and…
In this paper, we consider the packet-level forward error correction (FEC) code design, without feedback or with delayed feedback, for achieving the minimum end-to-end latency, i.e., the latency between the time when packet is generated at…
Within the project management context, project scheduling serves as an indispensable component, functioning as a fundamental tool for planning, monitoring, controlling, and managing projects more broadly. Although the resource-constrained…
This paper considers the discrete convexity of a cross-layer on-off transmission control problem in wireless communications. In this system, a scheduler decides whether or not to transmit in order to optimize the long-term quality of…
In feed-forward time-sensitive networks with Deficit Round-Robin (DRR), worst-case delay bounds were obtained by combining Total Flow Analysis (TFA) with the strict service curve characterization of DRR by Tabatabaee et al. The latter is…
This paper considers the joint transceiver design for downlink multiuser multiple-input single-output (MISO) systems with coordinated base stations (BSs) where imperfect channel state information (CSI) is available at the BSs and mobile…
Triple Modular Redundancy (TMR) is a suitable fault tolerant technique for SRAM-based FPGA. However, one of the main challenges in achieving 100% robustness in designs protected by TMR running on programmable platforms is to prevent upsets…
In this paper, we consider the dynamic power control for delay-aware D2D communications. The stochastic optimization problem is formulated as an infinite horizon average cost Markov decision process. To deal with the curse of…
In this paper, we introduce Voltage Phasor Control (VPC), also known as Phasor Based Control, as a novel way of implementing Optimal Power Flow (OPF). Unlike conventional OPF, in which the power flow optimization broadcasts power…
Finite-time optimal feedback control for flow networks under information constraints is studied. By utilizing the framework of multi-parametric linear programming, it is demonstrated that when cost/constraints can be modeled or approximated…
This work considers the problem of transmitting multiple compressible sources over a network at minimum cost. The aim is to find the optimal rates at which the sources should be compressed and the network flows using which they should be…
This note proposes a distributed model predictive control (DMPC) scheme with switched cost functions for a class of spatially interconnected systems with communication constraints. Non-iterative and parallel communication strategy is…
The Chance-Constrained Parallel Machine Scheduling Problem (CC-PMSP) assigns jobs with uncertain processing times to machines, ensuring that each machine's availability constraints are met with a certain probability. We present a…
This paper introduces an algorithm able to detect and localize the occurrance of a fault in an Active Distribution Network, using the measurements collected by Phasor Measurement Units (PMUs). First, a basic algorithm that works under the…
Controller placement problem (CPP) is a key issue for Software-Defined Networking (SDN) with distributed controller architectures. This problem aims to determine a suitable number of controllers deployed in important locations so as to…