Related papers: Tunable kHz distributed feedback fiber laser enabl…
Light sources utilizing \c{hi}(2) parametric conversion combine high brightness with attractive operation wavelengths in the near and mid-infrared. In optical fibers it is possible to use \c{hi}(3) degenerate four-wave mixing in order the…
An all-polarization maintaining (PM) single-longitudinal-mode (SLM) erbium-doped fiber laser (EDFL) with ultra-high optical signal-to-noise ratio (OSNR), ultra-narrow linewidth and extremely high stability is proposed and experimentally…
We propose a feedback-assisted direct laser writing method to perform laser ablation of fiber optics devices in which their light-collection signal is used to optimize their properties. A femtosecond-pulsed laser beam is used to ablate a…
Thin-film lithium niobate (TFLN) has emerged as a promising platform for the realization of high performance chip-scale optical systems, spanning a range of applications from optical communications to microwave photonics. Such applications…
In this article we report the fabrication of a diode-pumped Dy,Tb:LiLuF4 waveguide laser operating in the yellow region of the visible spectrum. The circular depressed-cladding waveguides have been fabricated by direct femtosecond laser…
Short (40-200 microseconds) single focused CO2 laser pulses of energy of about 100 microJ were used to fabricate high quality concave micromirror templates on silica and fluoride glass. The ablated features have diameters of 20-100 microns…
Design of a mid-wave IR (MWIR) broad-band fiber-based light source exploiting four-wave mixing (FWM) in a meter long suitably designed highly nonlinear (NL) chalcogenide microstructured optical fiber (MOF) is reported. This superior FWM…
Despite the wide applications for high-repetition-rate mode-locked fiber lasers, challenges persist in shortening the cavity length and coupling the fiber collimators for most existing techniques. Here, we introduce a novel collimator…
Rare-earth-doped fiber lasers are emerging as promising high-power mid-infrared sources for the 2.6-3.0 {\mu}m and 3.3-3.8 {\mu}m regions based on erbium and holmium ions. The intermediate wavelength range, however, remains vastly…
An ultrafast laser delivering 10.4 kW average output power based on coherent combination of twelve stepindex fiber amplifiers is presented. The system emits close-to-transform-limited 254 fs pulses at 80 MHz repetition rate, has a high beam…
We demonstrate a broadband mid-infrared (MIR) frequency comb source based on difference frequency generation (DFG) in periodically poled lithium niobate (PPLN) crystal. Mid-infrared radiation is obtained via mixing of the output of a 125…
Low-noise lasers are of central importance in a wide variety of applications, including high spectral-efficiency coherent communication protocols, distributed fibre sensing, and long distance coherent LiDAR. In addition to low phase noise,…
A novel mode-locked fiber laser based on offset splicing technology between two kinds of graded index multimode fibers is proposed and experimentally demonstrated. The offset splice spot structure acts as a saturable absorber via nonlinear…
We propose and demonstrate a high performance four-wavelength erbium-doped fiber laser (EDFL), enabled by a figure-8 compound-ring-cavity (F8-CRC) filter for single-longitudinal-mode (SLM) selection and a polarization-managed four-channel…
Dielectric laser acceleration (DLA) represents a promising approach to building miniature particle accelerators on a chip. However, similar to conventional RF accelerators, an automatic and reconfigurable control mechanism is needed to…
We demonstrate mode-locking of a thulium-doped fiber laser operating at 1.94\mu m, using a graphene-based saturable absorber. The laser outputs 3.6ps pulses, with~0.4nJ energy and an amplitude fluctuation~0.5%, at 6.46MHz. This is a simple,…
Ultrafast lasers are becoming increasingly widespread in science and industry alike. Fiber-based ultrafast laser sources are especially attractive because of their compactness, alignment-free setups, and potentially low costs. However,…
The phase synchronization of two semiconductor DFB lasers submitted to both frequency-shifted cross-injection and self-feedback is investigated, both numerically and experimentally. A dedicated setup based on monolithic DFB lasers permits…
We demonstrate that by using 1-m-long gas-filled hollow capillary fiber (HCF) with a core diameter of 100 {\mu}m, tunable ultraviolet (UV) dispersive-wave (DW) pulses can be generated in a compact, single-stage set-up driven directly by…
High-power ultra-low noise single-mode single-frequency lasers are in great demand for interferometric metrology. Robust, compact all-fiber lasers represent one of the most promising technologies to replace the current laser sources in use…