Related papers: Maximizing Uplink and Downlink Transmissions in Wi…
This paper initiate the application of rate splitting multiple access (RSMA) for simultaneous lightwave information and power transfer (SLIPT), where users require to decode information and harvest energy. We focus on a time-splitting (TS)…
We consider a dual-hop full-duplex relaying system, where the energy constrained relay node is powered by radio frequency signals from the source using the time-switching architecture, both the amplify-and-forward and decode-and-forward…
Energy harvesting multi-hop networks allow for perpetual operation of low cost, limited range wireless devices. Compared with their battery operated counterparts, the coupling of energy and data causality constraints with half duplex relay…
In this paper, the entire IoT-fog-cloud architecture is modelled, the service placement problem is optimized through Mixed Integer Linear Programming (MILP) and the total power consumption is jointly minimized for processing and networking.…
In this paper, we propose a novel design for the rotary-wing unmanned aerial vehicle (UAV)-enabled full-duplex (FD) wireless-powered Internet of Things (IoT) networks. In this network, the UAV is equipped with an antenna array, and the $K$…
In this paper, we study information transport in multiplex networks comprised of two coupled subnetworks. The upper subnetwork, called the logical layer, employs the shortest paths protocol to determine the logical paths for packets…
In this work, we consider an energy harvesting device (EHD) served by an access point with a single antenna that is used for both wireless power transfer (WPT) and data transfer. The objective is to maximize the expected throughput of the…
This paper considers a wireless networked control system (WNCS) consisting of a dynamic system to be controlled (i.e., a plant), a sensor, an actuator and a remote controller for mission-critical Industrial Internet of Things (IIoT)…
This paper investigates a wireless powered mobile edge computing (WP-MEC) network with multiple hybrid access points (HAPs) in a dynamic environment, where wireless devices (WDs) harvest energy from radio frequency (RF) signals of HAPs, and…
The evolving landscape of the Internet of Things (IoT) has given rise to a pressing need for an efficient communication scheme. As the IoT user ecosystem continues to expand, traditional communication protocols grapple with substantial…
With the increase in demand for Internet of Things (IoT) applications, the number of IoT devices has drastically grown, making spectrum resources seriously insufficient. Transmission collisions and retransmissions increase power…
For the Internet of Things (IoT), there might be a large number of devices to be connected to the Internet through wireless technologies. In general, IoT devices would have various constraints due to limited processing capability, memory,…
This paper explores the potential of wireless power transfer (WPT) in massive multiple input multiple output (MIMO) aided heterogeneous networks (HetNets), where massive MIMO is applied in the macrocells, and users aim to harvest as much…
In this paper, we consider a three-node cooperative wireless powered communication system consisting of a multi-antenna hybrid access point (H-AP) and a single-antenna relay and a single-antenna user. The energy constrained relay and user…
We propose a novel distributed resource allocation scheme for the up-link of a cellular multi-carrier system based on the message passing (MP) algorithm. In the proposed approach each transmitter iteratively sends and receives information…
The joint design of spatial channel assignment and power allocation in Multiple Input Multiple Output (MIMO) systems capable of Simultaneous Wireless Information and Power Transfer (SWIPT) is studied. Assuming availability of channel state…
In this paper, we consider a light fidelity (LiFi)-enabled bidirectional Internet of Things (IoT) communication system, where visible light and infrared light are used in the downlink and uplink, respectively. In order to improve the energy…
This work focuses on the downlink communication of a multiuser MIMO system where the base station antennas and the users' receiving antennas are all active, but at each transmission, only a subset of the receive antennas is selected by the…
For a self-sustaining wireless communication system in Internet-of-Things (IoT) networks, energy harvesting (EH) can be implemented at each user node as a constant renewable power supply source. Hence, an investigation into the use of…
This letter focuses on integrating rate-splitting multiple-access (RSMA) with time-division-duplex Cell-free Massive MIMO (multiple-input multiple-output) for massive machine-type communications. Due to the large number of devices, their…