Related papers: Constant Modulus Waveform Design with Space-Time S…
Phase-modulated continuous-wave (PMCW) multiple-input multiple-output (MIMO) radar systems are known to possess excellent mutual interference mitigation capabilities, but require costly and power-hungry high sampling rate and high-precision…
Accurate reconstruction of static and rapidly moving targets demands three-dimensional imaging solutions with high temporal and spatial resolution. Radar sensors are a promising sensing modality because of their fast capture rates and their…
This paper aims to handle the joint transmitter and noncoherent receiver design for multiuser multiple-input multiple-output (MU-MIMO) systems through deep learning. Given the deep neural network (DNN) based noncoherent receiver, the…
Joint radar-communication (JRC) waveform can be used for simultaneous radar detection and communication in the same frequency band. However, radar detection processing requires the prior knowledge of the waveform including the embedded…
Hybrid analog and digital beamforming transceivers are instrumental in addressing the challenge of expensive hardware and high training overheads in the next generation millimeter-wave (mm-Wave) massive MIMO (multiple-input multiple-output)…
We address the problem of linear precoder (beamformer) design in a multiple-input multiple-output interference channel (MIMO-IC). The aim is to design the transmit covariance matrices in order to achieve max-min utility fairness for all…
Dynamic target detection using FMCW waveform is challenging in the presence of interference for different radar applications. Degradation in SNR is irreparable and interference is difficult to mitigate in time and frequency domain. In this…
The multiple-input multiple-output (MIMO) detection problem is a fundamental problem in modern digital communications. Semidefinite relaxation (SDR) based algorithms are a popular class of approaches to solving the problem because the…
This paper considers mutual interference mitigation among automotive radars using frequency-modulated continuous wave (FMCW) signal and multiple-input multiple-output (MIMO) virtual arrays. For the first time, we derive a general…
Recent applications of the Full Duplex (FD) technology focus on enabling simultaneous control communication and data transmission to reduce the control information exchange overhead, which impacts end-to-end latency and spectral efficiency.…
This study investigates subarray-level movable antenna (MA) architecture for multi-user MIMO (MU-MIMO) systems. Unlike conventional systems with fixed-position antennas (FPAs), the proposed scheme harnesses the additional positional degrees…
This paper investigates the spectrum sharing between a multiple-input single-output (MISO) secure communication system and a multiple-input multiple-output (MIMO) radar system in the presence of one suspicious eavesdropper. We jointly…
Reconfigurable intelligent surface (RIS)-aided cell-free (CF) massive multiple-input multiple-output (mMIMO) is a promising technology for further improving spectral efficiency (SE) with low cost and power consumption. However, conventional…
In this paper, we investigate the optimization problem of joint source and relay beamforming matrices for a twoway amplify-and-forward (AF) multi-input multi-output (MIMO) relay system. The system consisting of two source nodes and two…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
Distributed multiple-input multiple-output (D-MIMO) is a promising technology for simultaneous communication and positioning. However, phase synchronization between multiple access points in D-MIMO is challenging and methods that function…
In this paper, we propose a novel method for efficient implementation of a massive Multiple-Input Multiple-Output (massive MIMO) system with Frequency Division Duplexing (FDD) operation. Our main objective is to reduce the large overhead…
Any wireless communication system needs to specify a propagation channel model which acts as basis for performance evaluation and comparison. Spatial channel models can be divided into deterministic i.e ray tracing, measurement based which…
In dual-function radar-communication (DFRC) systems the probing signal contains information intended for the communication users, which makes that information vulnerable to eavesdropping by the targets. We propose a novel design for…
Future wireless communication systems are envisioned to support ultra-reliable and low-latency communication (URLLC), which will enable new applications such as compute offloading, wireless real-time control, and reliable monitoring.…