Related papers: Single-Layer Fe-Cu Interphase in Ferritic Steels S…
A detailed study has been carried out on $\gamma^\prime$ (AlAg$_2$) precipitates in Al-Ag and Al-Ag-Cu alloys to reconcile the conflicting reports on chemical ordering and stacking faults in this phase. High angle annular dark field…
Age hardening induced by the formation of (semi)-coherent precipitate phases is crucial for the processing and final properties of the widely used Al-6000 alloys. Early stages of precipitation are particularly important from the fundamental…
Segregation, precipitation, and phase separation in Fe-Cr systems is investigated. Monte Carlo simulations using semiempirical interatomic potential, first-principles total energy calculations, and experimental spectroscopy are used. In…
Using special quasirandom structures (SQS's), we perform first-principles calculations studying the metastable bcc NiCu and FeCu alloys which occur in Fe-Cu-Ni alloy steels as precipitated second phase. The mixing enthalpies, density of…
A multidisciplinary approach is presented to analyse the precipitation process in a model Al-Cu alloy. Although this topic has been extensively studied in the past, most of the investigations are focussed either on transmission electron…
A filamentary composite elaborated by cold drawing was processed by High Pressure Torsion (HPT). The nanostructure resulting from this severe plastic deformation (SPD) was investigated thanks to scanning electron microscopy, transmission…
Inspired by recent experimental realizations of two-dimensional (2D) metals and alloys, we theoretically investigate the stability and electronic properties of monolayer (ML) Fe-C compounds and pure Fe. According to our and others…
The formation of energetically favourable and metastable mineral phases within the Fe-H2O system controls the long-term mobility of iron complexes as well as other aqueous phase constituents in natural aquifers, soils and other…
Precipitation hardening, which relies on a high density of intermetallic precipitates, is a commonly utilized technique for strengthening structural alloys. Structural alloys are commonly strengthened through a high density of small size…
In the search for improved permanent magnets, fueled by the geostrategic and environmental issues associated with rare-earth-based magnets, magnetically hard (high anisotropy)-soft (high magnetization) composite magnets hold promise as…
Transition metals implanted in single crystal MgO can precipitate out at grain boundaries or remain embedded in bulk. Using first-principles calculations based on density functional theory we have calculated the thermodynamic stability and…
We apply a combinatorial approach to study the influence of Mg concentration on the precipitation kinetics in an Al-Cu-Li alloy using a diffusion couple made by linear friction welding. The precipitation kinetics is monitored in the…
Superconductivity in FeSe is strongly enhanced under applied pressure and it is proposed to emerge from anomalously coupled structural and magnetic phases. Small impurities inside the Fe plane can strongly disrupt the pair formation in FeSe…
The Fe1+xTe phase diagram consists of two distinct magnetic structures with collinear order present at low interstitial iron concentrations and a helical phase at large values of x with these phases separated by a Lifshitz point. We use…
FeSe$_{1-x}$S$_{x}$ superconductors are commonly considered layered van der Waals materials with negligible inter-layer coupling. Here, using inelastic neutron scattering to study spin excitations in single-crystal samples, we reveal that…
The precipitation microstructure of the \gamma' (AlAg2) intermetallic phase has been examined in aluminium-silver-copper alloys. The microstructure developed in an Al-0.90at.%Ag-0.90at.%Cu alloy was significantly different from that…
Reduced activation ferritic/martensitic (RAFM) steels are the leading candidate structural materials for first-wall and blanket components in fusion reactors. This work is the first in a series to provide a systematic roadmap of MX…
In this study, the role of elastic and interfacial energies in the shape evolution of T1 precipitates in Al-Cu-Li alloys is investigated using phase-field modeling. We employ a formulation considering the stoichiometric nature of the…
Density functional theory calculations within the generalized gradient approximation are employed to study the ground state of Co2FeAl. Various magnetic configurations are considered to find out its most stable phase. The ferromagnetic…
The influence of Fe content on the three-dimensional (3D) morphology of Fe-rich intermetallic phases (Fe phases), Al2Cu, and pores and mechanical properties of cast Al-5.0Cu-0.6Mn alloys with 0.5 and 1.0 wt. % Fe are characterized using…