Related papers: High-SNR Comparison of Linear Precoding and DPC in…
In this paper, we analyse the performance of a reconfigurable intelligent surface (RIS) aided system where the RIS is divided into subsurfaces. Each subsurface is designed specifically for one user, who is served on their own frequency…
In wireless communication systems, dual-polarized (DP) instead of single-polarized (SP) multiple-input multiple-output (MIMO) transmission is used to improve the spectral efficiency under certain conditions on the channel and the…
This paper introduces a reconfigurable intelligent surface (RIS) to support parameter estimation in machine-type communications (MTC). We focus on a network where single-antenna sensors transmit spatially correlated measurements to a…
This paper considers the joint impact of non-linear hardware impairments at the base station (BS) and user equipments (UEs) on the uplink performance of single-cell massive MIMO (multiple-input multiple-output) in practical Rician fading…
Linear precoding techniques can achieve near- optimal capacity due to the special channel property in down- link massive MIMO systems, but involve high complexity since complicated matrix inversion of large size is required. In this paper,…
In this paper, we propose a signal-aligned network coding (SNC) scheme for K-user time-varying multiple-input multiple-output (MIMO) interference channels with limited receiver cooperation. We assume that the receivers are connected to a…
This paper considers the large-scale fading precoding design for mitigating the pilot contamination in the downlink of multi-cell massive MIMO (multiple-input multiple-output) systems. Rician fading with spatially correlated channels are…
A reconfigurable intelligent surface (RIS) can shape the radio propagation environment by virtue of changing the impinging electromagnetic waves towards any desired directions, thus, breaking the general Snell's reflection law. However, the…
Extremely large-scale reconfigurable intelligent surface (XL-RIS) can effectively overcome severe fading and provide higher communication performance. However, current research on XL-RIS overlooks the discrete phase-shift characteristics of…
Thanks to the strong ability against the inter-cell interference, cell-free network is considered as a promising technique to improve network capacity. However, further capacity improvement requires to deploy more base stations (BSs) with…
In the scalar dirty multiple-access channel, in addition to Gaussian noise, two additive interference signals are present, each known non-causally to a single transmitter. It was shown by Philosof et al. that for strong interferences, an…
We consider a multi-cell massive MIMO system where a time-division duplex protocol is used to estimate the channel state information via uplink pilots. When maximum ratio combining (MRC) is used at the BSs, the re-use of pilots across cells…
A promising approach to deal with the high hardware cost and energy consumption of massive MIMO transmitters is to use low-resolution digital-to-analog converters (DACs) at each antenna element. This leads to a transmission scheme where the…
Reconfigurable intelligent surface (RIS) has been recognized as a promising technology for next-generation wireless communications. However, the performance of RIS-assisted systems critically depends on accurate channel state information…
Network coding (NC), in principle, is a Layer-3 innovation that improves network throughput in wired networks for multicast/broadcast scenarios. Due to the fundamental differences between wired and wireless networks, extending NC to…
This paper considers reconfigurable intelligent surface (RIS)-assisted point-to-point multiple-input multiple-output (MIMO) communication systems, where a transmitter communicates with a receiver through an RIS. Based on the main target of…
Channel estimation in reconfigurable intelligent surface (RIS) assisted multiple input multiple output (MIMO) communication systems is challenging as pilots cannot be decoded at or transmitted from a RIS with only passive elements. We…
The incorporation of reconfigurable intelligent surface (RIS) into massive multiple-input-multiple-output (mMIMO) systems can unleash the potential of next-generation networks by improving the performance of user equipments (UEs) in service…
Reconfigurable intelligent surface (RIS) is a promising technology to enhance the spectral efficiency of wireless communication systems. By optimizing the RIS elements, the performance of the overall system can be improved. Yet, in contrast…
A reconfigurable intelligent surface (RIS) can shape the radio propagation by passively changing the directions of impinging electromagnetic waves. The optimal control of the RIS requires perfect channel state information (CSI) of all the…