Related papers: High-SNR Comparison of Linear Precoding and DPC in…
Physical-Layer Network Coding (PNC) is an effective technique to improve the throughput and latency in wireless networks. However, there are two major challenges for PNC, especially when using higher order modulations: 1) phase…
Reconfigurable intelligent surface (RIS)-aided vehicle-to-everything (V2X) communication has emerged as a crucial solution for providing reliable data services to vehicles on the road. However, in delay-sensitive or high-mobility…
The reconfigurable intelligent surface (RIS) is useful to effectively improve the coverage and data rate of end-to-end communications. In contrast to the well-studied coverage-extension use case, in this paper, multiple RIS panels are…
The reconfigurable intelligent surface (RIS) plays an important role in maintaining the connectivity in millimeter wave (mmWave) MIMO systems when the direct channel between the transceivers is blocked. However, it is difficult to acquire…
Reconfigurable intelligent surface (RIS) can significantly enhance the service coverage of Tera-Hertz massive multiple-input multiple-output (MIMO) communication systems. However, obtaining accurate high-dimensional channel state…
The downlink of a multiple-input multiple output (MIMO) broadcast channel (BC) is considered, where each receiver is equipped with a single antenna and the transmitter performs nonlinear Dirty-Paper Coding (DPC). We present an efficient…
We consider the downlink of a multi-cell massive MIMO system suffering from asymptotic rate saturation due to pilot contamination. As opposed to treating pilot contamination interference as noise (TIN), we study the performance of decoding…
A Non-Orthogonal Unicast and Multicast (NOUM) transmission system allows a multicast stream intended to all receivers to be jointly transmitted with unicast streams in the same time-frequency resource blocks. While the capacity of the…
Signal-to-leakage-and-noise ratio (SLNR) is a promising criterion for linear precoder design in multi-user (MU) multiple-input multiple-output (MIMO) systems. It decouples the precoder design problem and makes closed-form solution…
To keep massive MIMO systems cost-efficient, power amplifiers with rather small output dynamic ranges are employed. They may distort the transmit signal and degrade the performance. This paper proposes a distortion aware precoding scheme…
A communication link aided by a reconfigurable intelligent surface (RIS) is studied in which the transmitter can control the state of the RIS via a finite-rate control link. Channel state information (CSI) is acquired at the receiver based…
The integration of reconfigurable intelligent surfaces (RIS) with extremely large multiple-input multiple-output (MIMO) arrays at the base station has emerged as a key enabler for enhancing wireless network performance. However, this setup…
This paper analyses the performance of reconfigurable intelligent surface (RIS)-assisted device-to-device (D2D) communication systems, focusing on addressing co-channel interference, a prevalent issue due to the frequency reuse of sidelink…
In Reconfigurable intelligent surface (RIS)-assisted systems the acquisition of CSI and the optimization of the reflecting coefficients constitute a pair of salient design issues. In this paper, a novel channel training protocol is…
In this paper, Recofigurable Intelligent Surface (RIS) assisted dual-hop multicast wireless communication network is proposed with two source nodes and two destination nodes. RIS boosts received signal strength through an intelligent…
This paper studies the tension between throughput and decoding delay performance of two widely-used network coding schemes: random linear network coding (RLNC) and instantly decodable network coding (IDNC). A single-hop broadcasting system…
Massive multiple-input multiple-output (MIMO) and reconfigurable intelligent surface (RIS) are two promising technologies for 5G-and-beyond wireless networks, capable of providing large array gain and multiuser spatial multiplexing. Without…
To mitigate the effects of shadow fading and obstacle blocking, reconfigurable intelligent surface (RIS) has become a promising technology to improve the signal transmission quality of wireless communications by controlling the…
This paper investigates a smart spectrum-sharing framework for reconfigurable intelligent surface (RIS)-aided local high-quality wireless networks (LHQWNs) within a mobile network operator (MNO) ecosystem. Although RISs are often considered…
Beyond diagonal reconfigurable intelligent surface (BD-RIS) refers to a family of RIS architectures characterized by scattering matrices not limited to being diagonal and enables higher wave manipulation flexibility and large performance…