Related papers: Experimental demonstration of frequency downconver…
Modern ground-based gravitational wave (GW) detectors require a complex interferometer configuration with multiple coupled optical cavities. Since achieving the resonances of the arm cavities is the most challenging among the lock…
In this Perspective we summarize the status of technological development for large-area and low-noise substrate-transferred GaAs/AlGaAs (AlGaAs) crystalline coatings for interferometric gravitational-wave (GW) detectors. These topics were…
Laser frequency stabilization is notably one of the major challenges on the way to a space-borne gravitational wave observatory. The proposed Laser Interferometer Space Antenna (LISA) is presently under development in an ESA, NASA…
Laser frequency stabilization is a critical part of the interferometry measurement system of space-based gravitational wave observatories such as the Laser Interferometer Space Antenna (LISA). Arm locking as a proposed frequency…
Arm-locking frequency stabilization is a key technique for suppressing laser frequency noise in space-based gravitational-wave detectors. The robustness of the arm-locking control loop is crucial for maintaining laser frequency stability,…
Arm-locking is a technique for stabilizing the frequency of a laser in an inter-spacecraft interferometer by using the spacecraft separation as the frequency reference. A candidate technique for future space-based gravitational wave…
Thermal noise in high-reflectivity mirror coatings is a limiting factor in ground-based gravitational wave detectors. Reducing this coating thermal noise improves the sensitivity of detectors and enriches the scientific outcome of observing…
Laser frequency noise suppression is a critical requirement for the Laser Interferometer Space Antenna (LISA) mission to detect gravitational waves. The baseline laser stabilization is achieved using cavity pre-stabilization and a…
The sensitivity of 2nd and 3rd generations of interferometric gravitational wave detectors will be limited by thermal noise of the test-mass mirrors and highly reflective coatings. Recently developed crystalline coatings show a promising…
Arm locking is a technique that has been proposed for reducing laser frequency fluctuations in the Laser Interferometer Space Antenna (LISA), a gravitational-wave observatory sensitive in the milliHertz frequency band. Arm locking takes…
For space gravitational wave (GW) detection, arm locking is a proposal useful in decreasing the frequency noise of the laser sources for current developing space missions LISA and Taiji/TianQin. In this paper, we study the application of…
Residual motion of the arm cavity mirrors is expected to prove one of the principal impediments to systematic lock acquisition in advanced gravitational-wave interferometers. We present a technique which overcomes this problem by employing…
The Laser Interferometer Space Antenna (LISA) is a future space-based gravitational wave (GW) detector designed to be sensitive to sources radiating in the low frequency regime (0.1 mHz to 1 Hz). LISA's interferometer signals will be…
This paper presents a novel method for laser frequency stabilisation in the Laser Interferometer Space Antenna (LISA) mission by locking a laser to two stable length references - the arms of the interferometer and an on-board optical…
We present detailed numerical simulations of a laser phase stabilization scheme for LISA, where both lasers emitting along one arm are locked to each other. Including the standard secondary noises and spacecraft motions that approximately…
For the laser interferometer space antenna (LISA) to reach it's design sensitivity, the coupling of the free running laser frequency noise to the signal readout must be reduced by more than 14 orders of magnitude. One technique employed to…
LISA is an array of three spacecraft flying in an approximately equilateral triangle configuration, which will be used as a low-frequency detector of gravitational waves. Recently a technique has been proposed for suppressing the phase…
AlGaAs/GaAs coatings are being considered as coating candidates for gravitational-wave detectors. In this paper we investigate the birefringence properties of this crystalline semiconductor material by modulating the optical illumination on…
Higher-order Laguerre-Gauss (LG) modes have previously been investigated as a candidate for reducing test-mass thermal noise in ground-based gravitational-wave detectors like Advanced LIGO. It has been shown however that LG modes' fragility…
Crystalline materials are promising candidates as substrates or high-reflective coatings of mirrors to reduce thermal noises in future laser interferometric gravitational wave detectors. However, birefringence of such materials could…