Related papers: Optimal Beamforming for Bistatic MIMO Sensing
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) relay wireless network, in which a source-destination pair both equipped with multiple antennas communicates through a large number of half-duplex…
Utilizing communication signals to extract motion parameters has emerged as a key direction in Vehicle-to- Everything (V2X) networks. Accurately modeling the relationship between communication signals and sensing performance is critical for…
This paper studies a challenging scenario in a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system where the locations of the sensing target and the communication user are both unknown and random, while…
Through spatial multiplexing and diversity, multi-input multi-output (MIMO) cognitive radio (CR) networks can markedly increase transmission rates and reliability, while controlling the interference inflicted to peer nodes and primary users…
We consider the problem of angle-robust joint transmit waveform and receive filter design for colocated Multiple-Input Multiple-Output (MIMO) radar, in the presence of signal-dependent interferences. The design problem is cast as a max-min…
The integration of sensing and communication (ISAC) functionalities have recently gained significant research interest as a hardware-, power-, spectrum- and cost- efficient solution. This experimental work focuses on a dual-functional radar…
The focus of this paper is on beamforming in a millimeter-wave (mmW) multi-input multi-output (MIMO) setup that has gained increasing traction in meeting the high data-rate requirements of next-generation wireless systems. For a given MIMO…
In this work, we investigate a multistatic MIMO-OFDM joint sensing and communication (JSC) system that leverages cooperation among spatially distributed base stations (BSs) to detect and localize multiple targets through soft fusion of…
Orthogonal Frequency-Division Multiplexing (OFDM) is widely used in modern wireless communication systems due to its robustness against time-dispersive channels. In this work, we consider a non-cooperative scenario where the receiver does…
This letter develops an optimum beamforming method for downlink transmissions in cell-free massive multiple-input multiple-output (MIMO) systems, which employ a massive number of distributed access points to provide concurrent services to…
Dual-functional radar-communication (DFRC) systems can simultaneously perform both radar and communication functionalities using the same hardware platform and spectrum resource. In this paper, we consider multi-input multi-output (MIMO)…
In this paper, we consider hybrid beamforming designs for multiuser massive multiple-input multiple-output (MIMO)-orthogonal frequency division multiplexing (OFDM) systems. Aiming at maximizing the weighted spectral efficiency, we propose…
Conventional monostatic radar systems typically exhibit a trade-off between long-range target detection achieved through narrow beams and short-range wide-area surveillance employing broad beams. Realizing both functionalities within a…
This paper investigates the optimization of beamforming design in a system with integrated sensing and communication (ISAC), where the base station (BS) sends signals for simultaneous multiuser communication and radar sensing. We aim at…
The performance of millimeter wave (mmWave) communications strongly relies on accurate beamforming both at base station and user terminal sides, referred to as beam alignment (BA). Existing BA algorithms provide initial yet coarse angle…
In this paper, the multiple-input multiple-output (MIMO) transmit beampattern matching problem is considered. The problem is formulated to approximate a desired transmit beampattern (i.e., an energy distribution in space and frequency) and…
Multibeam technology enables the use of two or more subbeams for joint communication and radio sensing, to meet different requirements of beamwidth and pointing directions. Generating and optimizing multibeam subject to the requirements is…
Fully digital massive MIMO systems with large numbers (1000+) of antennas offer dramatically increased capacity gains from spatial multiplexing and beamforming. Designing digital receivers that can scale to these array dimensions presents…
Low-resolution analog-to-digital converters (ADCs) and hybrid beamforming have emerged as efficient solutions to reduce power consumption with satisfactory spectral efficiency (SE) in massive multiple-input multiple-output (MIMO) systems.…
We consider the problem of monostatic radar sensing with orthogonal frequency-division multiplexing (OFDM) joint radar-communications (JRC) systems in the presence of phase noise (PN) caused by oscillator imperfections. We begin by…